6ES7 193-7CB00-0AA0
Siemens Main Menu | SIMATIC S7 | Siemens ET 200 | PDF Manuals
6ES7 193-7CB00-0AA0 — Siemens ET 200iSP TM-RM/RM Terminal Module
Series: SIMATIC ET 200iSP
Product type: TM-RM/RM screw-terminal base for relay electronic modules
Order number: 6ES7193-7CB00-0AA0
6ES7 193-7CB00-0AA0 is the TM-RM/RM terminal module for ET 200iSP, part of the Siemens ET 200 distributed I/O family. It provides the base for the relay electronic modules and their field wiring. When selecting ET 200 terminal blocks, check the supported electronics rather than relying on a similar housing.
Terminal base and relay electronics
The base accommodates two 2 DO Relay UC60V/2A electronic modules. A reserve module, product version 03 or later, can also occupy a compatible slot. Switching is performed by the fitted electronics; the terminal base does not provide working relay outputs on its own. When reviewing ET 200 digital output modules, identify the electronics and the base as separate components.
“UC60V/2A” is not the supply rating of this terminal base. It belongs to the designation of the compatible relay electronic module. Check that module’s electrical limits and the connected load type before selecting a load.
Key technical details
Field connections: Ex e screw terminals.
Isolation arrangement: Ex d isolating plug between the relay electronics and field terminals.
Dimensions: 60 × 190 × 52 mm (width × height × depth).
Layout: Two electronic-module slots; the base can be prewired before the electronics are fitted.
Selection and replacement checks
1. Confirm the system family. Within the ET 200 system architecture, this base belongs to ET 200iSP. Do not assume interchangeability with ET 200S or ET 200SP bases. Even where a SIMATIC S7 control system is installed, order against the actual remote station hardware list.
2. Identify each station component. ET 200 communication interface modules and ET 200 power supply modules serve separate functions. TM-RM/RM does not replace either the station interface or its power supply.
3. Compare the wiring arrangement. Similar-looking ET 200 connection modules should not be assumed to share terminal assignments or electronic-module compatibility. Compare the existing label, slot arrangement and wiring diagram before ordering.
4. Check completeness. For a used unit, inspect the terminal cover, isolating plug, screws and locking parts. When sourcing ET 200 additional modules and accessories, establish exactly which components are included in the offer.
Use in hazardous areas
The Siemens product information requires the Ex e terminal cover to remain closed during operation and intrinsically safe wiring to be separated from other circuits. Disconnect the load voltage before wiring. Do not carry out installation work in an explosive atmosphere. Check the applicable zone, enclosure and certification conditions in the ET 200iSP documentation available through our Siemens ET 200 PDF manuals page.
Editor’s note
Start by matching the exact base number to the relay electronics you intend to install. Electronics shown in a photograph are not automatically included in the price. A missing cover, damaged isolating mechanism or altered terminals deserves more scrutiny than a simple “tested working” description. Use the Otomasyon AVM Siemens product enquiry page to send the full model number, quantity and clear label photographs.
PDF manuals and technical documentation
The references used for this model are TM-RM/RM product information A5E01672287-01 and ET 200iSP Operating Instructions A5E00247483-04, section 9.6. Visit the ET 200 manuals and PDF links page for documentation access. Confirm that the document and certificate apply to your installed hardware revision.
Related topics and Siemens navigation
Terminal blocks | Digital output modules | Connection modules
Additional modules and accessories | Communication interfaces | Power supply modules
Siemens Main Menu | SIMATIC S7 | Siemens ET 200 | PDF Manuals