6ES7321-7BH00-0AB0
Siemens 6ES7321-7BH00-0AB0 S7-300 SM 321 Digital Input Module
Siemens 6ES7321-7BH00-0AB0 is an SM 321 module with 16 digital inputs rated at 24 V DC and support for hardware and diagnostic interrupts. It acquires field signals in SIMATIC S7-300 systems. When choosing a replacement for an existing machine, compare the interrupt and diagnostic functions used as well as the input count.
Input arrangement and sensor supplies
The inputs form one isolation group of 16 channels. The module provides two short-circuit-protected sensor supplies, each serving eight channels. These supplies do not divide the inputs into two independently isolated groups of eight.
When selecting a sensor, assess its output type, operating voltage and supply requirements together. Replacing an inductive sensor or photoelectric sensor requires more than matching the number of connections: check the existing cabinet drawing and the module's sensor connection requirements.
Configurable input delay and hardware interrupts
Available input-delay settings are 0.1 / 0.5 / 3 / 15 / 20 ms, with a 3 ms default. Hardware interrupts are configured in pairs of channels for rising edges, falling edges or both. Interrupt functions are disabled by default and must be configured in STEP 7.
Select the delay with the duration of the signal to be detected in mind. For applications involving short pulses, assess sensor response time, input filtering and event handling in the S7-300 CPU program together. Changing settings without recording the existing configuration can alter the machine's signal-detection behaviour.
Diagnostic coverage and the 7BH00 version
Missing sensor supply diagnostics are evaluated for input groups 0–7 and 8–15. A supply-group fault may require several inputs in that group to be investigated together. Wire-break diagnostics must not be attributed to the 7BH00 version. Siemens' PCS 7 documentation specifies this function for 7BH01.
20-pin connection and project checks
Field wiring uses a 20-pin front connector. Confirm separately whether it is included with the offered unit. Before replacement, compare terminal numbers, L+ and M connections, sensor supplies and wire labels against a diagram covering the 7BH00 order number.
Check the module position, input start address, filter setting and interrupt configuration in the STEP 7 project. For installations using ET 200M, include interface-module and project compatibility in the assessment. The Siemens S7 PLC range provides related products for general system selection.
Evaluating a used module
Inspect the nameplate, hardware version, front-connector socket, rear connections and latches. In a suitable test setup, check all 16 inputs individually, both sensor supplies and the interrupt/diagnostic functions required by the project. Illuminated input LEDs alone do not establish that every module function has been checked.
Provide the complete order number, required quantity and a clear photograph of the existing module's nameplate when requesting a quotation. Match any available test record to the offered unit and specify the connector and accessory scope separately.
PDF files and technical references
Visit the S7-300 PDF files section for related documents. Confirm that the selected manual covers 6ES7321-7BH00-0AB0; a section describing only 7BH01 must not be used as the source for every feature of this version.
Manufacturer references: Siemens archived module documentation | 7BH00 and 7BH01 diagnostic notes, section 4.3.1 | 7BH00 connection example, appendix C.9
Related topics and product groups
Siemens S7-300 | S7-300 CPU modules | S7-300 digital output modules | S7-300 PDF files
Siemens S7 PLC | Used Siemens | Used automation equipment | OtomasyonAVM