6ES7321-1BH02-0AA0

Siemens 6ES7321-1BH02-0AA0 SM321 Digital Input Module

Siemens 6ES7321-1BH02-0AA0 is an SM321 module for the SIMATIC S7-300 family, with 16 digital inputs rated for 24 V DC. It enables the PLC to read status signals from pushbuttons, limit switches and compatible proximity sensors. Field wiring uses a 20-pin front connector. Typical applications include machine status monitoring, position detection and sequential automation.

Input voltage and sensor compatibility

The logic “1” input range is 13–30 V DC, while the logic “0” range is −30 to +5 V DC. Typical input current at logic “1” is 7 mA, with IEC 61131 Type 1 input characteristics. In addition to switches, electrically compatible two-, three- and four-wire proximity sensors can be used. The maximum permissible quiescent current for two-wire sensors is 1.5 mA. Sensor selection should account for off-state leakage, on-state voltage drop and cable voltage loss.

Input delay and signal monitoring

At rated input voltage, delay is 1.2–4.8 ms for both rising and falling transitions and is not configurable. Each channel has a green status LED. The module provides no hardware interrupts or diagnostic functions. When assessing when a signal will be processed, consider the S7-300 CPU cycle and program structure as well.

Isolation, mounting and wiring

The inputs form one group of 16 channels isolated from the backplane bus; individual channels are not independently isolated. Siemens specifies that all 16 inputs may be active simultaneously with horizontal mounting up to 60 °C or vertical mounting up to 40 °C. Cabinet temperature, mounting orientation and the remaining system installation requirements must also be checked.

Before replacement, verify the complete order number, 20-pin connector assignment and M reference connection. Check the hardware configuration and input addresses in the existing Siemens PLC project. Different modules within the SM321 family should not be assumed to have equivalent wiring or functionality.

Used-module inspection and quotation

When assessing a used Siemens module, inspect label readability, the housing, front connector and backplane connections. In a suitable test setup, apply controlled 24 V DC signals to each of the 16 channels, verify both switching states, and compare the LEDs with the PLC input readings. An illuminated LED on one channel does not establish that the entire module works. Qualified personnel should perform these checks under conditions that prevent unintended effects on machine operation.

For a quotation, provide order number 6ES7321-1BH02-0AA0, the required quantity, a photograph of the existing module label and any front-connector requirement. Product condition, test coverage, connector inclusion and delivery contents should be confirmed for the specific unit offered.

Technical documentation

Refer to the Siemens product data sheet for electrical specifications and section 3.9 of the S7-300 Module Data manual for wiring and operating details. Further documents are available on the S7-300 files page.

Related topics and product groups

S7-300 modules · S7-300 CPU modules · S7-300 digital output modules · S7-300 PDFs and manuals

Siemens PLC products · Used Siemens products · Used automation products · OtomasyonAVM