6ES7 194-4BC00-0AA0

Siemens Main Menu › SIMATIC S7 › ET 200 Modules

Siemens 6ES7 194-4BC00-0AA0 — ET 200pro CM PM-E Direct Connection Module

6ES7 194-4BC00-0AA0 is the CM PM-E Direct connection module for ET 200pro, part of the Siemens ET 200 family. It fits onto a PM-E power module and connects the 24 V DC load supply, 2L+, through screw terminals. This component belongs to the ET 200 connection module range; it does not generate a 24 V supply itself.

Its role alongside the PM-E

The 6ES7148-4CA00-0AA0 / PM-E DC 24V establishes a new load potential group within the station. CM PM-E Direct provides its cable connections. Treat ET 200 power supply modules and their connection modules as separate components. X01 provides 2L+ and 2M supply connections plus additional terminals for forwarding the supply.

Technical characteristics and current limits

Connection: Direct wiring with screw terminals. Cable entry: Up to two M20 cable glands. Dimensions: 45 × 130 × 100 mm (width × height × depth). 2L+ feed current: 16 A.

The 16 A connection feed rating does not permit drawing 16 A through the station's internal busbar. Siemens limits the ET 200pro internal 2L+ busbar to 10 A. Keep this distinction when planning power distribution and potential groups. Also check the capacity of the 24 V power supply, cable sizing and the individual channel ratings of the digital output modules.

Differences from similar connection modules

6ES7194-4BA00-0AA0 is the CM PM-E ECOFAST version; 6ES7194-4BD00-0AA0 uses a 7/8-inch connection. The 4BC00 described here is the Direct version. Match your cable and connector selection to the installed wiring. Sharing the PM-E family does not make these versions interchangeable without wiring changes.

Five checks before selection

1. Subfamily and matching module: Check the ET 200 system architecture to confirm ET 200pro and the full order number of the power module. Specify the power module and connection module separately when ordering.

2. Supply arrangement: Trace the source of 2L+ and 2M in the schematic. Include the total current carried by the forwarded supply; two cable entries do not represent two independent power channels.

3. Terminal preparation: Siemens specifies flexible conductors of 0.14–2.5 mm², one conductor per terminal and an 11 mm stripping length for the screw terminal connections. This connection range does not mean every permitted conductor size can carry 16 A.

4. Cable glands and cover: Match the cable diameter to the gland's clamping range. Inspect the seals, cover and unused entries; enclosure appearance alone does not establish proper sealing.

5. Functional distinction: This module connects the load supply. It does not replace PROFIBUS and PROFINET communication interfaces. Investigate supply faults and network faults with separate measurements.

Editor's Note

A station that communicates while its outputs remain inactive can initially suggest an output module fault. First check the affected group's 2L+ load supply, connections and the fuse in the PM-E. The CM connection module and PM-E are separate components; replacing only the connection module will not resolve a fuse fault inside the power module. Disconnect the relevant supplies before removal or wiring.

PDF and wiring information: Use ET 200pro Operating Instructions, 09/2015, A5E00335544-AJ alongside our Siemens ET 200 manuals and PDF documents page. Pages 128–129 cover wiring, 282–283 describe the connection module, and 323–326 explain the PM-E and supply connections.