6ES7 132-0HF00-0XB0
Siemens Main Menu › SIMATIC S7 › ET 200 Modules
Siemens 6ES7 132-0HF00-0XB0 — ET 200B 16-Channel AC Digital Output Module
6ES7 132-0HF00-0XB0 is the ET 200B-16DO-AC electronics block in the Siemens ET 200 distributed I/O family. It provides 16 outputs rated at 120/230 V AC, with 0.5 A per channel. When selecting from ET 200 digital output modules for AC loads, include temperature and mounting conditions in the assessment.
ET 200B construction and terminal selection
This 235 mm-wide electronics block uses the TB6/AC terminal block. Outputs are galvanically isolated in groups of four. When comparing ET 200 terminal blocks, verify the base type and wiring diagram as well as mechanical fit. Record changes to connection modules and terminal arrangements in the panel documentation; verify existing bridges before reusing them.
Within the ET 200 system and product families, identify this device as ET 200B. Do not interpret 0HF00 as the “High Feature” designation used for ET 200S products. The similar 6ES7131-0HF00-0XB0 is an input module, so the 131/132 distinction matters.
Temperature, loads and protection
In the preferred mounting position, channel current is 0.5 A at 0–40 °C and 0.35 A at 40–60 °C. Other mounting positions are rated 0.35 A at 0–40 °C. The manual specifies no internal output short-circuit protection; assess external protection with the load and installation design.
Maximum switching frequency is 10 Hz for resistive loads, 0.5 Hz for inductive loads and 1 Hz for lamps. When selecting contactors and coil loads, examine inrush as well as steady current. Low normal operating current alone does not establish suitability under all conditions.
Phase arrangement at 230 V
On 230 V AC systems, 1L1/1N and 2L1/2N must share one phase; 3L1/3N and 4L1/4N must also share a phase within that pair. Preserve this arrangement when reviewing power distribution and potential groups. Group isolation does not permit arbitrary phase assignment.
Five checks before selection
1. Labels and base: Record the electronics-block and terminal-block codes separately. Confirm whether the quotation includes the electronics alone or the complete assembly.
2. Load conditions: Check AC voltage, channel currents, panel temperature and mounting orientation. Previous service history alone is insufficient if the connected loads have changed.
3. Communication: The module uses PROFIBUS-DP. When reviewing ET 200 communication interfaces, check the master, station address, bus termination and project records together.
4. Program mapping: In an installation using a SIMATIC S7 control system, match output addresses to field labels. Back up the project and photograph the existing connections before replacement.
5. Functional test: Compare output commands with actual load response. Where available, check running or position feedback from ET 200 digital input modules and record the results.
Editor's Note
If several loads in one group fail together, inspect their common supply, neutral, connections and external protection before replacing the module. Distinguishing a single-channel fault from a group or station fault helps avoid unnecessary replacement.
PDF manuals and wiring diagrams: Visit the Siemens ET 200 manuals and PDF documents page. The ET 200B manual, EWA 4NEB 812 6089-02c, covers this product in section 7.3.12, printed pages 7-79 to 7-83.
Related Topics
Digital Output Modules · Terminal Blocks · Connection Modules · Communication Interfaces
Otomasyon AVM
Siemens Main Menu ·
SIMATIC S7 ·
ET 200 Modules ·
ET 200 PDF Manuals ·
PLC and HMI