6ES7307-1EA00-0AA0
Siemens 6ES7307-1EA00-0AA0 – PS307 24 V DC / 5 A Power Supply
6ES7307-1EA00-0AA0 is a Siemens SIMATIC S7-300 PS307 power supply with a 24 V DC / 5 A output. Its nominal voltage and current give a calculated output power of 120 W. When comparing industrial power supplies, consider the complete order number, mains voltage, load demand and cabinet layout together.
120/230 V AC input and manual voltage selection
The unit operates from a single-phase 120/230 V AC, 50/60 Hz supply. This version uses a manual mains voltage selector. Siemens specifies a factory setting of 230 V AC; the selector position on a used unit should be checked rather than assumed.
Before commissioning, verify that the actual mains voltage matches the selector setting. Connections comprise L1, N and protective earth at the input and L+ and M at the output. Qualified personnel should select the voltage, install and wire the unit with the supply disconnected. Cable sizing and supply protection should match the cabinet design.
Output capacity and load calculation
5 A is the total rated output current. Additional output terminals do not increase this capacity. Siemens specifies that parallel operation is not supported for this model. Higher demand requires a suitably rated supply or separately supplied load groups.
Include the CPU module, digital input circuits, loads supplied through digital outputs and any other connected equipment in the calculation. Assess continuous current demand separately from starting and simultaneous switching currents.
If analog modules, transmitters and HMI panels share the supply, check cable voltage drop and interactions between loads. Intermittent supply problems also warrant checking connections and load distribution.
Protection and mechanical installation
The unit provides electronic short-circuit protection and a green output voltage LED. An illuminated LED alone does not establish satisfactory operation at rated load. Evaluate measured voltage, connected load and heating together.
The housing is 80 mm wide and mounts on an S7-300 profile rail. Before replacement, check the mounting arrangement, cable ducts, terminal access and cabinet airflow. Existing cables should reach without strain, with sufficient access for maintenance.
Assessing a used power supply
When assessing used Siemens equipment, inspect the nameplate, voltage selector, terminals and covers. A suitable test setup should establish output voltage at no load and under progressive loading, restart behaviour and heating. A report stating load current, measurements and test duration makes comparison easier.
Availability, price, supplied accessories and any warranty terms should be confirmed for the actual unit. Do not assume mounting or connection accessories are included. Base the purchase decision on both the model specifications and the condition of the offered equipment.
Related topics and product groups
S7-300 overview | S7-300 CPU modules | Digital input modules
Digital output modules | Function modules | Analog module range
Used Siemens products | Used equipment overview | OtomasyonAVM home
Manufacturer references
Siemens – S7-300 module data, section 2.3 (archived copy) | Siemens – hardware and installation manual | Siemens – product information for later PS307 versions