6ES5 700-0LA11
Siemens 6ES5 700-0LA11 – SIMATIC S5-115U CR 700-0 Central Rack
The Siemens 6ES5 700-0LA11 is a CR 700-0 central rack with four I/O module positions for SIMATIC S5-115U. The power supply, CPU and I/O modules connect through the rack backplane. The ADEGIS record for the exact part lists 353 × 303 × 47 mm (W × H × D). Allow space for installed modules and front connectors when checking cabinet depth.
Slot layout and hardware
The 1987 S5-115U approval lists the 0LA11 alongside the CPU 942 6ES5 942-7UA11, CPU 941 6ES5 941-7UA12 and power supplies including the PS 951 6ES5 951-7LD11 and PS 951 6ES5 951-7LB13. Match the CPU and power supply labels on the installed hardware when replacing a rack.
Figure 3-2 in the Siemens manual shows the PS, CPU, 0–3 and IM positions for the later 6ES5 700-0LA12. If the cabinet uses a CP 530-7, check slot 0. For a CP 523 or IP 242, check the installed part number and slot against the manual, including any 491-0LA12 type adapter casing.
Expansion and related racks
For centralized configurations, the Siemens manual lists fixed addressing and one expansion unit for IM 305, and variable addressing and up to three expansion units for IM 306. If the cabinet has an ER 701-0 and a 705-0AF00 connecting cable, record the interface, cable length and addressing layout together.
The Niemur spare-parts list identifies 0LA12 as the successor to 0LA11. The 0LB11 is a separate version with a layout for two-board adapters. When comparing the CR 700-1 6ES5 700-1LA11 and CR 700-2 6ES5 700-2LA11, check rack length, backplane connectors and IM position together.
Used rack and service checks
Before removing modules such as a 431-7LA11 digital input, 441-7LA11 digital output or 465-7LA12 analog input, record the slot numbers. Where modules use a 490-7LB11 front connector, photograph the wire labels as well. To offer a rack for sale, send photos of the full label and backplane to otomasyonavm@gmail.com.
Editor’s note
Isolate power. Photograph the PS, CPU, slots 0–3 and the IM position, including any empty slots.
Check the 0LA11 suffix on the label. If fitting a 0LA12, compare mounting holes, backplane connectors and the slot 0 adapter on both racks.
View the backplane pins from the side. If you find bent pins, discoloration or a broken module guide, inspect the damage before inserting a card.
Label the IM cable and record the terminator position before removal. In the 0LA12 layout, the IM terminator stays in place when neither IM 305 nor IM 306 is fitted.
Test local I/O and expansion I/O separately after replacement. If the local cards work but the expansion unit is missing, start with the IM cable and addressing layout.
PDFs and references
+ 1987 S5-115U approval (ES), exact 0LA11 part number and hardware table
+ Siemens S5-115U manual (EN), Figure 3-2 and slot chart for 0LA12
+ Siemens S5-115U manual (EN), IM 305 and IM 306 comparison on p. 3-19
+ ADEGIS 0LA11 part record and rack dimensions
+ Niemur S5 parts list, 0LA11 and successor 0LA12 on p. 29