6ES5 430-7LA12-Z
Siemens 6ES5 430-7LA12-Z — S5 Digital Input Module
Siemens 6ES5 430-7LA12-Z is an ordering reference associated with the SIMATIC S5-115U 430-7 digital input family. The 6ES5 430-7LA12 base model used for technical comparison provides 32 inputs rated at 24 V DC, arranged in four optocoupler-isolated groups of eight. Preserve the complete code when selecting from the S5 digital input range.
The electrical information below comes from Siemens’ documentation for the 6ES5 430-7LA12 base model. The manufacturer document examined does not explain the specific scope of the “-Z” suffix. Establish its meaning from the actual unit’s complete label and manufacturer order record; do not assume unconditional equivalence with the standard model.
Input characteristics of the 430-7LA12 base model
Nominal input voltage is 24 V DC. Specified levels are −30 to +5 V for logic “0” and +13 to +30 V for logic “1”. Typical current at logic “1” is 8.5 mA. Use these thresholds when assessing suitable 24 V DC control signals and relay contacts.
The base module accepts suitable two-wire proximity sensors. When choosing a two-wire sensor, check its off-state current and output voltage. Identify the sensor from its label before deciding on a connection from wire count alone.
Eight-input isolation groups and field wiring
Isolation is provided in groups of eight inputs, rather than per channel. Match each group’s supply and M reference to the front-connector wiring diagram. Assess the 24 V power supply, grounding and interference conditions together. A fault in one group’s reference connection can affect several inputs in that group.
Addressing and fault checks
The base model’s 32 inputs correspond to four input bytes. Establish the starting address from the rack arrangement, slot and addressing method of the installed interface module. Compare bit addresses in the PLC program with field-wire numbering. During troubleshooting, check the supply, group reference and input state separately.
Comparison with related part numbers
6ES5 430-7LA11 is a different revision code. 6ES5 420-7LA11 also has 32 inputs rated at 24 V DC but is non-floating, without galvanic isolation. 6ES5 431-7LA11 has different channel and signal specifications. The “430” designation or physical appearance alone is insufficient for selecting a spare.
Editor’s note
Read the full label carefully in this Siemens S5 system, and keep the “-Z” suffix on the order. Photograph any additional option codes and the hardware revision too. Matching the base number does not establish that every detail matches.
If a sensor fails to respond, first check terminal voltage and the M connection for its eight-input group. Separating a supply fault from a module fault often prevents an unnecessary replacement.
Ask for more than one or two illuminated channel LEDs. A suitable test should cover all 32 inputs and all four groups. A failure confined to one group of eight is a useful clue for deciding where to start.
Back up the program and memory arrangement, then record the connector, wire numbers and slot position before removal. Isolate the supply and verify that the equipment is de-energized. A clear photograph of the original wiring is valuable during replacement.
When buying a used Siemens module, look for the complete 6ES5 430-7LA12-Z code on the quotation and test record. Ask for the label, revision and existing application wiring to be checked against each other instead of relying on a verbal assurance of equivalence.
OtomasyonAVM resources and PDFs
+ 6ES5 430-7LA12 base-model page
Related topics
+ 6ES5 430-7LA11 — different revision
+ 6ES5 420-7LA11 — non-floating input
+ 6ES5 431-7LA11 — different input class
Browse SIMATIC S5
+ S5 digital inputs · S5 cables and connectors
+ SIMATIC S5 overview · Used Siemens equipment