6ES5 266-8MA11
Siemens 6ES5 266-8MA11 – SIMATIC S5 IP 266 Positioning Module
The Siemens 6ES5 266-8MA11 (IP 266) performs closed-loop positioning on a linear or rotary axis. It reads actual position from an incremental encoder and sends a ±10 V analog speed reference to an external drive. The CPU starts the positioning job. The module runs the position loop internally.
Analog output and encoder
On the 9-pin ANALOG OUT D-Sub socket, pin 2 carries the speed reference and pin 4 is analog common. The ENCODER socket has 15 pins. Match the incremental encoder to the machine data, including 5 V differential RS-422 or 24 V single-ended signals, pulse count and reference mark. Check the signal type when buying a used encoder. If you suspect mechanical play, inspect the encoder coupling and mounting.
PG and ENCODER both use 15-pin sockets. Viewed from the front, PG is on the right. The bus unit terminals provide five digital inputs and three digital outputs. Refer to Figure 2-7 for the hardware limits, reference and external stop inputs, and outputs such as FUM and position reached.
S5 and ET 200U compatibility
The Siemens data sheet lists S5-90U, S5-95U, S5-100U and ET 200U. For S5-100U installations using a CPU 100, CPU 102 or CPU 103, check the slot and I/O address against the system manual. For a station with an ET 200U IM 318-B, check the IP 266 address identifier for the configured DP mode in section 9.11 of the ET 200U manual.
Identify the fitted 8MA11 screw-terminal or 8MA21 crimp bus unit and any EMC variant such as 8FA11 or 8MA22. On multi-tier stations, record the IM 315 or IM 316 link as well. Verify mechanical fit, I/O addressing and terminal wiring separately.
How IP 266 differs from other S5 modules
The IP 263 handles rapid and creep positioning, the IP 265 is a high-speed subcontrol module, and the IP 267 controls stepper motors. The IP 241 position decoder and the IP 246 positioning module belong to separate hardware families. Match the exact part number, interfaces and machine data when sourcing a spare. To offer a module for sale, send photos of the label and sockets to otomasyonavm@gmail.com.
Editor’s note
Before removing the module, back up the machine data and traversing programs with COM 266. Keep the CPU program and IP 266 data as separate files.
With power isolated, label the PG, ENCODER and ANALOG OUT plugs separately. Photograph the positions of the two 15-pin connectors.
Match the encoder’s 5 V or 24 V rating to the machine data. With the drive disabled, check feedback on the COM 266 actual-value display.
If motion fails to start, record the FAULT LED state and COM 266 error message first. Then check for valid machine data, the FUM signal and external start enable.
If actual position stays unchanged during a following error, inspect the encoder circuit, coupling and drive-ready state. Run the first movement test in controlled maintenance mode after verifying the limits and emergency stop.
PDFs and Siemens references
+ Siemens 6ES5266-8MA11 data sheet (EN)
+ Siemens IP 266 manual (EN), connections in chapter 2 and COM 266 in chapter 6
+ Siemens ET 200U manual (EN), IP 266 section 9.11
+ Siemens ST 50 (EN), IP 266 applications and compatibility