6ES7 141-1BF00-0AB0
Siemens automation › SIMATIC S7 › Siemens ET 200 › 6ES7141-1BF00-0AB0
Siemens 6ES7 141-1BF00-0AB0 ET 200X BM 141 ECOFAST Digital Input Module
6ES7 141-1BF00-0AB0 is an ET 200X BM 141 ECOFAST basic module with 8 digital inputs rated at 24 V DC. Communication uses copper PROFIBUS DP / RS 485. When researching this product within the Siemens ET 200 distributed I/O family, check the complete order number and the ECOFAST connection arrangement together.
Eight M12 sockets and input connections
Sockets X1–X8 each carry one input: the input signal uses pin 4, while pin 2 is unassigned. When comparing ET 200 digital input modules, include the connection layout in your selection. Check the pin assignments of existing sensor cables before preparing a cable list. Use the module-specific socket drawing when reviewing ET 200 connection components.
The input ranges are 13–30 V for “1” and −3–5 V for “0”, with an input delay of 1.2–4.8 ms in either direction. For short pulses, assess the sensor pulse duration together with the sampling behavior of the PLC program.
ECOFAST power and communication arrangement
The module has unswitched 24 V-NS and switched 24 V-S supplies, without galvanic isolation between them. Keep the machine wiring diagram available when researching ET 200 power supply options and power distribution components. The PROFIBUS and PROFINET interfaces page helps compare system architectures; this order number uses PROFIBUS DP.
Compatibility checks for older expansion modules
Siemens product information A5E00125915-05, dated 01/2005, restricts the use of 6ES7141-1BF30-0XA0 and 6ES7141-1BD30-0XA0 with this ECOFAST basic module. For 6ES7148-1DA00-0XA0, the restriction applies only to product release 1. A sensor cable short circuit can affect the shared 24 V supply line. On older stations, compare expansion module order numbers and product releases with this dated document.
Five checks before selection or replacement
1. Complete order number: Read 6ES7141-1BF00-0AB0 from the label. When reviewing the ET 200 system architecture, record the identities of the basic module and each expansion module separately.
2. Connection arrangement: Photograph the ECOFAST connections, sensor cables and socket condition. Verify series compatibility before treating items in the ET 200 terminal blocks category as suitable for this module.
3. Expansion requirements: When selecting ET 200 digital output modules or ET 200 analog input modules, check ET 200X compatibility and the manufacturer's restrictions on module combinations.
4. Project matching: Back up the existing hardware configuration, PROFIBUS address and input addresses. After replacement, operate the sensors individually and confirm their corresponding signals in the program.
5. Document matching: Check that the technical section of the manual identifies the complete order number. Avoid transferring specifications from a similarly named product to the installed module.
Editor's note: Selecting a replacement for an older ET 200X station requires more than the basic module label. Keeping the expansion sequence, each component's product release and cable connections in one record saves repeating the same research during future maintenance.
Manuals and PDF documentation
Visit the Siemens ET 200 PDF documentation and user manuals page for ET 200X resources. For this model, read the technical data in A5E00158282-05, section 7.2, together with the compatibility information in A5E00125915-05.
Related topics
Power and connections: Power supply modules · Terminal blocks · Connection modules · Power distribution modules
Explore the station: About ET 200 · Communication interfaces · ET 200 manuals
Otomasyon AVM | Siemens:
Siemens main menu |
Siemens S7 PLC |
SIMATIC S7 |
ET 200 modules