6ES5 254-4UB21

Siemens 6ES5 254-4UB21 · IP 254 MOBY-M interface module

The 6ES5 254-4UB21 is an IP 254 interface connecting a SIMATIC S5 system to a MOBY-M identification station. It belongs to the S5 special modules range. It passes information from the pallet or workpiece data carrier to the PLC for processing. In the RFID identification chain, it handles communication between the station and the PLC.

Reader and connections

Siemens calls the MOBY-M read/write station an LBS in its family documentation. Available operations depend on the type of data carrier. When documenting the S5 interface module and communications hardware, record the full LBS order number as well. The 4UB21 service listing shows three connections and LED indicators. Label each connection and the other end of its cable before removal. Use the machine wiring drawing for connector functions.

Record the installed rack order number and slot. Identify the module and station supply points separately from the wiring drawing. For electrical checks, verify the relevant supply and cable continuity under the site procedure. If an external signal triggers the station, watch the relevant PLC digital input as well.

Variant selection and STEP 5 backup

Several IP 254 variants among the S5 modules have similar front panels. Part records identify the 4UA21 as MOBY-M and the 4UB11 as MOBY-SP. Match the 4UB21 suffix, LBS type and cable labels together when sourcing a spare. Some secondary records list 6AW5463-0AB as a successor candidate. Verify the wiring, rack and program against the installed system before changing over.

Back up the STEP 5 project before changing the S5 system. Record the CPU and memory module order numbers, IP 254 access address, relevant program blocks and the data area used after a read. If the cabinet has a communications converter, verify the interface type on both sides against the drawing. Use the device and wiring details to identify the serial interface type.

Editor’s note

+ Ask for clear photos of the 4UB21 label and front connectors. Ask which LBS and data carrier were used for testing and whether the connecting cable is included.

+ Before removal, photograph the rack, slot and cable labels. Record the STEP 5 blocks that access the IP 254 and the expected data area from the working project.

+ If one station stops reading, safely isolate the equipment and inspect that station’s plug and cable. Then repeat the test at the same position with a known good carrier.

+ If several stations stop responding together, check their common supply and PLC access to the interface. Record the LED states during the fault and compare them with the machine’s fault table.

+ If a read completes but the PLC identifies the wrong pallet, compare the carrier ID with the raw data received by the PLC. If the ID is correct, inspect the byte offset and data length used by the program.

+ After replacement, read a carrier with a known ID and verify the expected PLC data. If the application writes data, use a dedicated test carrier and read back the value afterwards.

To sell a module, email the full order number, quantity, operating condition, label and connector photos and asking price to otomasyonavm@gmail.com.

PDFs and product references

+ Siemens ES 030-K manual, MOBY-M and LBS family information, p. 2-3 (EN)

+ 6ES5 254-4UB21 service listing for the exact part number (EN)

+ 6AW5463-0AB successor record, secondary source (EN)

+ Siemens S5 PDF archive

Related topics

+ What is RFID?

+ RFID tags and data carriers

+ About Siemens S5 PLCs

Second-hand Siemens

+ S5 special modules

+ S5 90/110 modules

+ Siemens S5

+ Second-hand Siemens main page