6ES5 700-2LA11

Siemens 6ES5 700-2LA11 – SIMATIC S5-115U CR 700-2 Central Rack

The Siemens 6ES5 700-2LA11 is a CR 700-2 central mounting rack for SIMATIC S5-115U. The power supply, CPU and installed modules connect through the rack backplane. This version is used in distributed configurations and provides seven module positions.

Slot layout and hardware

The CR 700-2 drawing in the S5-115U manual shows dedicated PS, CPU and IM positions and module positions 0–6. The ADEGIS record for the exact part lists dimensions of 483 × 303 × 47 mm (W × H × D). Allow additional cabinet depth for the installed cards, front connectors and cable bends.

Siemens Application Note 244 shows this exact rack with the CPU 944 6ES5 944-7UA22 and PS 951 6ES5 951-7LD12. The 1987 S5-115U approval also lists the CPU 942 6ES5 942-7UA11 and PS 951 6ES5 951-7LD11. For a service replacement, check the full part numbers of the CPU and power supply in the cabinet.

Interfaces and rack variants

For local expansion, check the IM 306 link and ER 701-1 rack. For a distributed configuration using the IM 304 and IM 314, record the interface, cable and termination at the ER 701-2 or ER 701-3 end as well. Figure 3-5 of the manual shows IM 304/308 in slot 6 with an adapter casing. Leave the terminating connector in the IM position when neither IM 305 nor IM 306 is fitted.

The spare-parts listing identifies the 6ES5 700-2LA12 as the successor to 2LA11. The 6ES5 700-2LA22 is the S5-115F CR 700-2F rack. The 6ES5 700-2LB11 uses a different layout for two-board adapters. When comparing the CR 700-1 and CR 700-3, check the interface and adapter positions as well as the number of slots.

Used rack checks

Record the slots used by cards such as the 431-7LA11 digital input, 441-7LA11 digital output and 465-7LA12 analog input before removal. If the cabinet has the 0GA11 mounting kit and 0HA11 fan subassembly, check the cable duct position and the clearance required to service the fan. To offer a rack for sale, send photos of the label and backplane connectors to otomasyonavm@gmail.com.

Editor’s note

Isolate power. Take one photo that shows the power supply, CPU, slots 0–6 and the IM position, including any empty slots.

Check the 2LA11 suffix and hardware revision on the label. If offered a 2LA12, compare the two backplane connector layouts and adapter positions side by side.

Inspect the backplane for bent pins, discoloration and loose connectors. If a card does not seat squarely, check the guide rail and connector alignment first.

Label the destination rack for each IM cable and record the terminator position. Return the cable and terminator to their recorded positions during reassembly.

During controlled commissioning, check CPU diagnostics, local I/O and remote stations separately. If local I/O works but the remote rack is missing, start with the IM link and its termination.

PDFs and references

Siemens S5 PDF archive

Related topics

Second-hand Siemens navigation

S5 mounting racks · SIMATIC S5 · Siemens S5 PLC · Second-hand Siemens