6ES5 263-8MA12

Siemens 6ES5 263-8MA12 SIMATIC S5 IP 263 two-axis positioning module

The 6ES5 263-8MA12 is a SIMATIC S5 IP 263 positioning module for rapid traverse and creep speed on two independent axes. The full-order-number parts record lists incremental or absolute SSI encoder feedback and use with S5-90U, S5-95U, S5-100U and ET 200U. For ET 200U, check the installed IM 318-B interface and station configuration.

Positioning and field connections

In Siemens’ IP 263 family description, the axis travels rapidly toward its target, changes to creep speed at the configured switchover point and drops the movement command at the cutoff point. The manual describes rapid, creep and two direction commands for each channel. With an incremental encoder, check count direction and the reference procedure. Use the cabinet schematic to distinguish the limit switch from the reference sensor. Match the digital input and digital output signals to the relevant axis.

Start troubleshooting with the S5 cables and connectors, then check the relevant power supply and station interface. If the S5-100U uses a bus unit such as the 700-8MA11, verify the installed unit’s order number and terminal type. The detailed tables in the Siemens references cover versions 8MA11 and 8MA13. For 8MA12 wiring, use the pin assignments, voltages and addresses documented for the installed hardware and machine.

Revision and replacement checks

The IP 263 8MA11 and IP 263 8MA13 have separate order numbers in the same family. The IP 266 is for closed-loop position control, the IP 267 for stepper control, and the IP 265 for high-speed subcontrol. Before replacing the card, record the rack and bus unit layout and the function module address in the PLC. The Siemens 8MA13 reference describes addressing in S5-100U like a four-channel analog module. Verify the 8MA12 address in the existing STEP 5 project.

Editor’s note

1. When buying used, ask for close-ups of the 263-8MA12 label, hardware revision and both encoder sockets. Ask whether the test covered both axes.

2. Back up the STEP 5 project and axis data before replacement. Record the reference position, scaling, switchover and cutoff settings separately.

3. Isolate cabinet and field supplies and verify that power is off. Label each encoder cable with its axis number and photograph the connector positions before unplugging them.

4. If the position reads correctly but the axis stays still, check the PLC motion enable and the direction and speed commands to the drive separately.

5. If the axis overshoots, check the change to creep speed and the cutoff point first. Investigate backlash and brake delay before changing the target offset.

6. During controlled recommissioning, test each axis separately. Observe actual-position direction, the reference run and the approach to the target.

Manuals and references

+ Siemens S5-100U manual, IP 263 8MA13 family reference (EN)

+ Siemens ET 200U manual, section 9.8, IP 263 8MA11 (EN)

+ Full-order-number parts record, 6ES5 263-8MA12 (EN)

+ SIMATIC S5 PDF archive

Related topics

+ About Siemens S5 PLC

+ SIMATIC S5 modules

Used Siemens equipment

+ S5 positioning modules

+ SIMATIC S5

+ Siemens S5 PLC

+ Used Siemens main page