The error code F0422 is indicating that there is no load applied to the inverter. This can result in some functions not working as they would under normal load conditions.

To diagnose and remedy this issue, the following step should be taken:

    Apply a load to the inverter.

It is recommended to refer to the manual or documentation for the inverter system (F0001) for more detailed information on troubleshooting this issue, as well as information on the recommended load conditions for the inverter to function properly.

The error code F0450 is indicating a failure in the BIST (Built-In Self Test) routines for the inverter system. The specific cause of the failure can be determined by referring to the fault value r0949.

To diagnose and remedy this issue, the following steps should be taken:

    Check the fault value r0949 to determine the specific cause of the failure.
    If the drive is still functional but several functions are not correctly executed, replace the drive.

It is recommended to refer to the manual or documentation for the inverter system (F0001) for more detailed information on troubleshooting this issue and interpreting the fault value r0949.

The error code F0452 is indicating a load torque fault detected in the inverter system. The cause of the error could be due to load conditions at the motor that signify a load torque fault, such as a belt failure or a mechanical fault.

To diagnose and remedy this issue, the following steps should be taken:

    Check for any issues with the mechanical drive transmission line, such as braking, failure, or destruction.
    Lubricate the mechanical drive transmission line if necessary.
    If an external encoder is being used, check the parameter settings for P2192 (delay time, load torque monitoring).
    If operating within a specific speed range, check the following parameters:
    P2182 (load torque monitoring F1)
    P2183 (load torque monitoring F1f2)
    P2184 (load torque monitoring F1f3)
    P2185 (upper torque threshold 1)
    P2186 (lower torque threshold 1)
    P2187 (upper torque threshold 2)
    P2188 (lower torque threshold 2)
    P2189 (upper torque threshold 3)
    P2190 (lower torque threshold 3)
    P2192 (delay time, load torque monitoring)

It is recommended to refer to the manual or documentation for the inverter system (F0001) for more detailed information on troubleshooting this issue and adjusting the relevant parameters.

The error code F0453 is indicating a motor stall in the inverter system. The cause of the error could be due to a number of factors, such as:

    Up/or down ramp too steep (excessive gradient)
    Inverter connected to an already spinning motor without using the flying restart function
    Motor incorrectly connected
    Motor too small
    Voltage boost P1611 for sensorless vector control too low

To diagnose and remedy this issue, the following steps should be taken:

    Check the motor connections.
    Increase the ramp-up time (P1120) or the ramp-down time (P1121).
    Activate the flying restart function (P1200).
    Use a larger motor.
    Increase the voltage boost (P1611) for sensorless closed-loop vector control.
    Use closed-loop vector control with an encoder instead of sensorless closed-loop vector control.
    Activate the V/f closed-loop control mode (P1300 less than 20) instead of closed-loop vector control.

It is recommended to refer to the manual or documentation for the inverter system (F0001) for more detailed information on troubleshooting this issue and adjusting the relevant parameters.

+ Micromaster User manuals >

- MicroMaster Fault code 1 >

- MicroMaster Fault code 2 >

- MicroMaster Fault code 3 >

- MicroMaster Fault code 4 >

- MicroMaster Fault code 5 >

- MicroMaster Fault code 6 >

- About Siemens Micromaster >>

++ Siemens Homepage