6ES7326-1BK02-0AB0

Siemens 6ES7326-1BK02-0AB0 S7-300 SM 326 Fail-Safe Digital Input Module

Siemens 6ES7326-1BK02-0AB0 is an SM 326 F-DI module with 24 digital inputs rated at 24 V DC. Part of the SIMATIC S7-300 family, it acquires safety-related field signals in compatible SIMATIC F-systems. It supports applications up to SIL 3 / PL e under the specified system and wiring conditions; these ratings do not automatically establish the safety level of the complete machine.

24 inputs and dual-channel evaluation

The module supports 1oo1 and 1oo2 sensor evaluation. Single-channel 1oo1 operation provides 24 signals; configuring every input for dual-channel 1oo2 evaluation provides 12 input pairs. Siemens specifies SIL 2 applications for 1oo1 and SIL 3 applications for 1oo2 under the applicable conditions. Selection must account for the sensor arrangement, wiring method and safety project.

Electrical characteristics and sensor supplies

The inputs form two electrically isolated groups of 12. The specified logic levels are −30 to +5 V for “0” and +11 to +30 V for “1”. The module has four short-circuit-protected sensor supplies; these are not digital outputs for controlling field loads. Match sensor wiring to the manufacturer's diagram for the selected internal or external supply arrangement.

Siemens specifies a maximum unloaded current consumption of 450 mA from the load supply, a maximum of 100 mA from the 5 V backplane bus and a typical power loss of 10 W. Include sensor loads separately when calculating cabinet power and thermal requirements.

Connection, diagnostics and system compatibility

Field wiring requires a 40-pin front connector. Module dimensions are 80 × 125 × 120 mm, stated as width, height and depth. Confirm separately whether the connector is included. Use a terminal diagram covering the exact 6ES7326-1BK02-0AB0 order number.

The module provides a diagnostic alarm, an SF group-fault indicator, a SAFE safety-mode indicator and channel status LEDs. Check the compatible F-CPU and software configuration, PROFIsafe address, sensor evaluation and discrepancy time together. When selecting from S7-300 CPU modules, verify support for the required safety functions. For ET 200M installations, include the interface module and system version in the compatibility assessment.

Checks when purchasing a used module

For a used Siemens unit, inspect the complete order number, hardware version, serial number, connector socket and rear connections. A test record should identify the inputs, sensor supplies, F-communication and diagnostic checks covered. Illuminated LEDs or readable inputs in standard mode alone do not verify the safety functions. Assess reuse against the unit's history and the safety validation required for the particular machine.

Provide the complete model code, required quantity and a clear nameplate photograph when requesting a quotation. Match the connector and accessory scope, and any available test report, to the specific unit being offered.

PDF files and manufacturer references

Visit the S7-300 PDF files section for related documentation. For this product, use Siemens' Fail-safe signal modules manual together with its supplementary product information.

Manufacturer references: Siemens technical data sheet | Fail-safe signal modules manual | Supplementary product information

Related topics and product groups

Siemens S7-300 | S7-300 CPU modules | S7-300 digital output modules | S7-300 PDF files

Siemens S7 PLC | Used Siemens | Used automation equipment | OtomasyonAVM