6ES7321-1BH50-0AA0

Siemens 6ES7321-1BH50-0AA0 – S7-300 SM 321, 16 Inputs, 24 V DC, Source Input

6ES7321-1BH50-0AA0 is an SM 321 module with 16 digital inputs rated at 24 V DC in the Siemens SIMATIC S7-300 family. Siemens describes it as a source input module. It uses a 20-pin front connector.

Input logic and sensor compatibility: The manufacturer’s wiring diagram shows that an input becomes active when pulled towards M/0 V. This arrangement matches NPN, current-sinking sensor outputs with suitable electrical ratings. Contacts and compatible two-, three- or four-wire proximity sensors can be used. Two-wire sensors must have an off-state current of 1.5 mA maximum.

Voltage reference: Siemens specifies input thresholds relative to L+: −30 to −13 V for signal “1” and −5 to +30 V for signal “0”. For example, with L+ at +24 V, pulling an input to 0 V produces −24 V relative to L+ and is recognized as “1”. These negative values do not require a separate negative power supply.

Isolation and connections: All sixteen inputs share one common group. Optical isolation separates the input group from the backplane bus; individual channels are not isolated from each other. When replacing a digital input module, compare the L+ common connection and field signal current direction with the manufacturer’s diagram.

Response time and status monitoring: Input delay is 1.2–4.8 ms in both transition directions and cannot be parameterized. Each channel has a green status LED. There are no hardware interrupts, diagnostic interrupts or module diagnostic functions. Also consider the CPU scan cycle when reading short pulses.

Simultaneous operation: All 16 inputs may be active simultaneously with horizontal installation up to +60 °C or vertical installation up to +40 °C. Review mounting orientation, ventilation and the operating limits of other station components when planning the panel layout.

Project compatibility and used modules: Check the complete order number, hardware revision, STEP 7 hardware definition and input addresses. For a used module, review terminal condition, repair history and whether channel tests used the correct input logic. Confirm whether the front connector and backplane bus connector are included.

PDF files and manuals: Use the S7-300 files section for wiring and technical data. Refer to the SM 321; DI 16 × DC 24 V; source input chapter that explicitly covers 6ES7321-1BH50-0AA0.

Related topics and categories
S7-300 main page | S7-300 digital input modules | S7-300 digital output modules | S7-300 CPU modules
PLCs and modules | DIN rail power supplies | S7-300 files | Second-hand main page | OtomasyonAVM home

Manufacturer references: Siemens – product information | Siemens – S7-300 Module Data, section 3.13