RSTi-EP CPE100 Controller

CPE100 is a controller, not an RSTi-EP remote I/O slice. Its networking and programming capabilities define the system architecture.

EPSCPE100 is documented with four Ethernet ports across two LANs, RS-232 and 1 MB of user memory. These are controller properties and should not be assigned to a connected remote I/O module.

CPE100 controls remote-I/O slices; four Ethernet ports do not imply four identical network roles. Preserve a machine’s separation between control traffic and engineering access where present. Project and firmware revisions matter as much as connector count.

Selection details that matter

Verify the full EPSCPE100 code, firmware and Machine Edition revision separately.

Model characteristics and roles

EPSCPE100: 4 Ethernet ports / 2 LAN; RS-232; 1 MB user memory.

Software and project backup

PAC Machine Edition / Proficy Machine Edition belongs to the control and motion project. Match axis/network configuration to project version, firmware and the installed PAC hardware before replacing a module or controller. RSTi-EP CPE100 Controller requires the project target to match the complete hardware designation.

For the backup and version requirements of RSTi-EP CPE100 Controller, read Proficy Machine Edition and Logic Developer PLC.

Finding the applicable manual

RSTi-EP CPE100 Controller: Documents for controller, network and firmware selection. Relevant document reference: GFK-3012; CPE100 Data Sheet 09/2019.

The document scope and future PDF location for RSTi-EP CPE100 Controller are explained in GE-Fanuc PLC and PAC Manuals.

Relevant model codes

Compact PAC: EPSCPE100.

Where to go next

VersaPoint Remote I/O and PACMotion Control Modules explain the adjacent parts of this system without treating them as interchangeable.

Explore GE-Fanuc products

After reading about RSTi-EP CPE100 Controller, you can browse the available listings in the GE-Fanuc second-hand main category. Check each product page for its current availability and condition.