PACMotion Control Modules
A PACMotion module brings motion axes into the control system; it is neither a servo motor nor a servo drive.
IC695PMM335 is recorded as a four-axis RX3i motion-control module. The module issues axis commands; it does not by itself define the motor or drive power rating.
PACMotion issues axis commands from a PAC system; it is not the power stage that drives the motor. Controller firmware, network path and application project matter alongside axis count. Record axis order and feedback connections before replacing a module.
Selection details that matter
Evaluate the IC695PMM335 code together with PAC CPU and connected drive interface.
Model characteristics and roles
IC695PMM335: RX3i; 4 axes.
Software and project backup
PAC Machine Edition / Proficy Machine Edition belongs to the control and motion project. Match axis/network configuration to project version, firmware and the installed PAC hardware before replacing a module or controller. PACMotion Control Modules requires the project target to match the complete hardware designation.
For the backup and version requirements of PACMotion Control Modules, read Proficy Machine Edition and Logic Developer PLC.
Finding the applicable manual
PACMotion Control Modules: Shows the system boundary between the axis module and PAC controller. Relevant document reference: GFK-2448A.
The document scope and future PDF location for PACMotion Control Modules are explained in GE-Fanuc Servo and Motion-Control Manuals.
Relevant model codes
Motion-control module: IC695PMM335.
Where to go next
VersaMotion Servo Drives and RSTi-EP CPE100 Controller explain the adjacent parts of this system without treating them as interchangeable.
Explore GE-Fanuc products
After reading about PACMotion Control Modules, you can browse the available listings in the GE-Fanuc second-hand main category. Check each product page for its current availability and condition.