Omron V7 fault codes


Omron V7 Protective and Diagnostic Functions

Inverter Alarms:

    Alarm Display: Minor faults cause the Digital Operator to flash. Operation continues and is automatically restored once the cause is removed. Minor fault status can be output to external devices.
    Fault Display: Major faults trigger the protective function, causing the Digital Operator to light up and the output to shut off, stopping the Inverter. The fault can be output to external devices.

Resetting Faults:

    Turn ON the reset signal with the Run Command OFF or cycle the power after corrective action.

Common Faults and Corrective Actions

    UV (Main Circuit Low Voltage):
        Check: power supply voltage, main circuit connections, and terminal screws.
        If no problem is found, the Inverter may be faulty.

    OV (Main Circuit Overvoltage):
        Similar checks and actions as UV.

    OH (Heatsink Overheat):
        Check: intake air temperature, ensure no thermal sources are around the Inverter, and that the fan is not clogged.

    CAL (MEMOBUS Communications Waiting):
        Check: communication devices, signals, PLC, transmission cable, and wiring.

    OH8 (Motor Overheating):
        Check: load size, acceleration/deceleration times, V/f characteristics, and motor temperature.

    OP (Constant Setting Error):
        Check: for multiple values set for multi-function input selection, correct relationships among V/f constants, and appropriate settings for motor rated current and frequency reference limits.

    OL3 (Overtorque Detection):
        Reduce the load: increase acceleration/deceleration time, check wiring, and refer to Carrier Frequency Selection.

    SER (Sequence Error):
        Check: NO/NC contact selection, wiring, and PLC signals.

    UL3 (Undertorque Detection):
        Check: the setting in n118 and operating conditions.