Omron V7 fault codes 2

BB (External Baseblock):

    Check: NO/NC contact selection, wiring, and PLC signals.

EF (Simultaneous FWD/REV Run Commands):

    Check: NO/NC contact selection, wiring, and PLC signals.

STP (Operator Function Stop / Emergency Stop):

    Turn OFF: FWD/REV Run Command of control circuit terminals and check wiring and signals.

FAN (Cooling Fan Fault):

    Check: the cooling fan, connection, and ensure nothing is obstructing rotation.

CE (MEMOBUS Communications Fault):

    Check: communication devices, signals, PLC, transmission cable, and wiring.

FBL (PID Feedback Loss Detection):

    Check: the mechanical system and correct the cause, or increase the value of n137.

Option Card Communications Fault:

    Check: communication devices, signals, PLC, transmission cable, wiring, and ensure the option card is inserted correctly.

OC (Overcurrent):

    Check: for short circuits or grounding at the Inverter output side, excessive load, rapid acceleration/deceleration times, special motor use, starting motor during coasting, and leak current due to long wiring.

GF (Grounding):

    Check: the cause and restore operation, ensuring no short-circuit or ground fault occurs at the Inverter output.

SC (Load Short Circuit):

    Similar checks and actions as GF.

OV (Main Circuit Overvoltage - Running):

    Check: for large regenerative energy, short deceleration time, excessive negative load, and input voltage errors.

UV1 (Main Circuit Low Voltage - Running):

    Similar checks and actions as UV, with additional checks while the Inverter output is ON.

UV2 (Control Power Supply Fault):

    Replace the Inverter.