Omron 3G3rV fault codes 4
Errors when Using the Digital Operator Copy Function:
Meaning: Errors that can occur when using the copy function from the Digital Operator.
Probable Causes: Various errors related to the copy function.
Corrective Actions: Error code will be displayed on the Digital Operator. Pressing a key will clear the display.
Er-11 Motor Speed:
Meaning: Motor speed error during rotational autotuning.
Probable Causes: Torque reference too high during acceleration.
Corrective Actions: Disconnect motor from machine, increase acceleration time, and check input data.
Er-12 I-det Circuit:
Meaning: Current detection error.
Probable Causes: Current flow exceeded motor rated current, incorrect current detection circuit, phase fault for U, V, or W.
Corrective Actions: Check current detection circuit, motor wiring, current detector, and installation methods.
Er-13 Leak Inductance:
Meaning: Leakage inductance error.
Probable Causes: Autotuning not completed in specified time, check motor wiring.
Corrective Actions: Check motor wiring.
End1 V/f Over Setting:
Meaning: V/f settings excessive during autotuning.
Probable Causes: Torque reference exceeded 100%, no-load torque exceeded 70% during autotuning.
Corrective Actions: Check and correct settings, disconnect load from motor.
End2 Saturation:
Meaning: Motor core saturation error during rotational autotuning.
Probable Causes: Autotuning for motor core saturation value could not be completed in specified time.
Corrective Actions: Check input data, check motor wiring, disconnect motor from machine if connected.
End3 Rated FLA Alm:
Meaning: Rated current setting alarm.
Probable Causes: Rated current set high.
Corrective Actions: Check input data, particularly motor output current and rated current.
PrE READ IMPOSSIBLE:
Meaning: Digital Operator write-protected.
Probable Causes: o3-01 set to 1 to write a parameter when Digital Operator was write-protected (o3-02 = 0).
Corrective Actions: Set o3-02 to 1 to enable writing parameters with the Digital Operator.
ıFE READ DATA ERROR:
Meaning: Illegal read data.
Probable Causes: Read data length does not agree.
Corrective Actions: Repeat the read, check the Digital Operator cable, replace the Digital Operator.
rdE DATA ERROR:
Meaning: Illegal write status.
Probable Causes: Attempted write of a parameter to EEPROM on the Digital Writer failed.
Corrective Actions: Repeat the read, replace the Digital Operator.
CPE ID UNMATCH:
Meaning: ID not matched.
Probable Causes: Inverter product code or software number is different.
Corrective Actions: Use the copy function for the same product code and software number.
uAE INV. KVA UNMATCH:
Meaning: Inverter capacity unmatched.
Probable Causes: Capacity of the Inverter being copied and capacity in the Digital Operator are different.
Corrective Actions: Use the copy function for the same Inverter capacity.
CrE CONTROL UNMATCH:
Meaning: Control method unmatched.
Probable Causes: Control method of the Inverter being copied and control method in the Digital Operator are different.
Corrective Actions: Use the copy function for the same control method.
CyE COPY ERROR:
Meaning: Verify error.
Probable Causes: Parameter written to the Inverter was compared with the parameter in the Digital Operator and they were different.
Corrective Actions: Retry the copy.
CSE SUM CHECK ERROR:
Meaning: Checksum error.
Probable Causes: Checksum in the Inverter parameter area was compared with the checksum in the Digital Operator parameter area and they were different.
Corrective Actions: Retry the copy.