invt DA200 servo fault codes 8
INVT DA200 Servo Fault Codes 8
This section covers INVT DA200 servo drive faults related to CANopen communication, PDO mapping, synchronization, CAN receive/transmit errors and excessive bus load.
For these faults, check the CANopen network state, baud rate, synchronization source, RPDO/TPDO configuration and PDO mapping together rather than repeatedly resetting the servo drive.
Er26-9 - PDO Mapping Not Allowed
Possible cause:
A parameter that is not permitted for PDO mapping may have been included in the PDO configuration.
Checks and solutions:
Check the access properties of the mapped objects. Make sure read-only PDO parameters are not mapped to an RPDO.
Er26-a - Synchronization Signal Too Fast
Possible cause:
The received communication frames may be arriving faster than the configured baud rate can support.
Checks and solutions:
Increase the data-frame transmission interval or synchronization-frame interval from the master station. If necessary, reconfigure the CANopen communication baud rate.
Er26-b - CAN Receive Error
Possible cause:
CAN communication may have gone offline, or the error count may have exceeded 128.
Checks and solutions:
Check the CANopen communication cables, connectors and network connections. If the wiring is normal, restart the servo drive.
Er26-c - CAN Transmit Error
Possible cause:
CAN communication may have gone offline, or the error count may have exceeded 128.
Checks and solutions:
Inspect the CANopen communication cables and network connections. Restart the servo drive after verifying the wiring.
Er26-d - Duplicate Synchronization Signal
Possible cause:
A synchronization signal may be received from an external source while another synchronization signal is also being generated by a slave station, causing a conflict.
Checks and solutions:
Review the CANopen network configuration and make sure there is only one synchronization-signal source in the communication network.
Er26-e - Bus Load Too High
Possible cause:
In asynchronous operation mode, the number of frames received by the slave station may exceed the communication capacity available at the configured baud rate.
Checks and solutions:
Increase the data-frame transmission interval from the master station. Check and, if necessary, change the slave station's TPDO transmission mode. Adjust the CANopen baud rate to suit the network load.
Er26-f - Parameter Modification State Error
Possible cause:
A parameter change may have been attempted while the CANopen device was in a state that does not permit that modification.
Checks and solutions:
According to the source information, set the CANopen state machine to Pre-OP or OP, then retry the parameter modification.
INVT DA200 Fault Code Document
+ INVT DA200 Servo Fault Codes (PDF)
Related INVT Servo Pages
+ INVT DA200 Servo Fault Code Index