IC697PWR748
48 VDC, 90W Power Supply Module (IC697PWR748)
This power supply module is designed to provide stable power for IC697 systems. It plugs into the leftmost slot of the rack and supplies +5V, +12V, and -12V outputs. It's perfect for single or dual rack setups.
Key Features:
Operates on 48 VDC input voltage.
Supplies a total of 90 watts of power:
+5V DC: Up to 18 amps.
+12V DC: 1.5 amps.
-12V DC: 1 amp.
Easy slide-in rack mount design.
Electronic short-circuit and overcurrent protection on the 5V bus.
Supports dual rack operation from one power supply.
How It Works:
This module plugs directly into the 48-pin connector in the rack. It provides the necessary +5V, +12V, and -12V power and control signals. You can use it for a single rack or power a second rack, as long as the total load is within its capacity. The connection to the second rack is made using the IC697CBL700 cable.
This power supply can handle a brief power loss of up to 10 milliseconds without interruption. It’s protected against overvoltage and overcurrent conditions.
Dual Rack Operation:
You can power two racks with this power supply if:
The second rack only needs 5V power.
The second rack draws less than 5.2 amps.
The two racks are close enough for the 3-foot connecting cable.
Protection Features:
Overvoltage Protection: The power supply clamps the output if the 5V bus exceeds 6.7V, protecting the system.
Overcurrent Protection: Limits the current for each output (+5V: 26A, +12V: 4A, -12V: 2A).
Ride-Through Time: Keeps the system running for at least 10 milliseconds in the event of a power interruption, ensuring a safe shutdown.
Mounting & Installation:
The power supply is secured in the rack using M2.5 screws. Make sure the screws are properly tightened for good grounding.
Opening the power supply door is easy—just gently pull the upper-left corner.
Input Voltage & Grounding:
The power input terminal board provides two terminals for 48 VDC power and one for ground. Use AWG #16 to #12 copper wire to make the connections. Proper grounding is crucial—connect the GND terminal on the power supply to the rack’s GND terminal and then to an earth ground.
Warnings:
Even when the power switch is off, the internal components may still hold charge, so handle with care!
Technical Specifications:
Input Voltage Range: 35-60V DC.
Total Output Power: 90 watts.
Outputs: +5V, +12V, -12V.
Protections: Overvoltage and overcurrent protection on all outputs.
If you're running two racks, remember to use the IC697CBL700 Power Supply Extension Cable.
>> GE Fanuc IC697PWR748 User manual (pdf)
----------
+ Ge-Fanuc Contact (for Automation Mall)