IC697BEM713

Bus Transmitter Module (IC697BEM713)

The IC697BEM713 Bus Transmitter Module (BTM) is designed for expanding the main CPU rack in an IC697 PLC system when additional modules are needed. It facilitates communication between the main CPU and up to 7 additional expansion racks using a daisy-chain arrangement. Additionally, the BTM provides a high-speed parallel interface for connecting programming devices.

Key Features:

   • High-Performance Parallel Programmer Interface: Facilitates faster communication with the programmer.

   • Bus Expansion Interface: Supports connection of up to 7 expansion racks.

   • Three LED Status Indicators: Indicate the status of the module, programmer port, and expansion port.

   • Software Configuration: No need for DIP switches; configuration is done via MS-DOS or Windows programming software.

   • Up to 50 Feet Cable Length: Maximum cable length for connection to the last Bus Receiver Module (BRM) is 50 feet (15 meters).

Functions:

   • The BTM allows for the expansion of the main CPU rack when more I/O modules are required than can be accommodated within the CPU rack.

   • Provides a high-speed interface for programming devices using a parallel connection (compatible with MS-DOS programmers).

   • Connects to Bus Receiver Modules (BRMs) in expansion racks through a daisy-chained system, enabling seamless data communication between the CPU and the expansion racks.

   • The module is configured through software, making installation and setup easier.

LED Status Indicators:

   • MODULE OK (Top LED): Indicates the status of the BTM. It turns ON when the module is properly configured and communicating with the CPU.

   • Programmer Port Enabled (Middle LED): This LED blinks or stays ON when the programmer is actively communicating with the CPU.

   • Expansion Port Enabled (Bottom LED): Shows the status of communication with Bus Receiver Modules (BRMs) in the expansion racks. Blinks or stays ON during communication.

Installation:

   • Ensure that the rack power is OFF before installation.

   • Install the BTM in any slot in the main CPU rack (except for slot 1).

   • Push the module firmly into the backplane connector.

   • Power up the system.

Important Notes:

   • The BTM IC697BEM713A must be installed to the right of any IC697 interrupt source modules such as GBC, PCM, or integral inputs. Later versions of the BTM (IC697BEM713B and newer) can be installed in any appropriate slot.

   • The module includes a mechanical key that prevents incorrect module installation.



>> GE Fanuc IC697BEM713 User manual (pdf)

++ Other 90-30 PLC modules

----------

+ Ge-Fanuc 2 Homepage

+ Ge-Fanuc Contact (for Automation Mall)

+ About Ge-Fanuc

Reminder: GE Fanuc IC697BEM713 and other Ge-Fanuc modules are available for sale at Otomasyon Mall. Please note that some of the devices are used products, so take this into consideration when purchasing. However, once products are out of stock, new ones will not be restocked. The information above is based on general knowledge and does not guarantee accuracy. For more detailed and precise information, it is recommended to refer to the relevant device’s user manual. 06.03.2013 

"Please note: The user manuals, commissioning suggestions, error codes, and solution recommendations provided on this page are not binding. The information and documents above are open to and even in need of improvement. As the Otomasyon Mall Community, we gladly welcome your suggestions and contributions. If you have field experience and insights on ease of use, please do not hesitate to share them with us."