IC694DSM314
Multi-axis motion control module: IC694DSM314
The Motion Mate Module, IC694DSM314, is a multi-axis motion control module that supports two control loop configurations:
Standard Mode (Follower Control Loop Disabled)
Follower Mode (Follower Control Loop Enabled)
The IC694DSM314 Module can be used with digital GE Fanuc α Series and β Series digital servo amplifiers and motors. It is also compatible with analog GE Fanuc SL Series servos and third-party analog velocity command and torque command interface servos. The key features of this module include:
Velocity Feed Forward and Position Error Integrator
High resolution for programming units
Simple and powerful motion programming instruction set
Simple motion programs for 1 to 4 axes
Non-volatile memory for 10 programs and 40 subroutines
Single connection point for programming and configuration
Firmware stored in flash memory, updated via the COMM port
Recipe programming using command parameters
Electronic CAM capability
Home and overtravel switch inputs for each Servo Axis
Two Position Capture Strobe Inputs for each axis
5V, 24V, and analog I/O for use by the PLC
Incremental Quadrature Encoder input on each axis for Encoder/Analog mode
13-bit Analog Output controlled by PLC or used as a Digital Servo Tuning monitor
High-speed digital outputs (four 24V and four 5V) via on-board Local Logic control
Overview:
The DSM314 integrates high-performance motion control with the logic-solving capabilities of the RX3i PACSystem, allowing precise control over servo motors and amplifiers.
Key Components:
STAT LED: Normally On, indicates the module is functioning. Slow blinking shows status errors, and rapid blinking indicates critical errors that stop the servo.
OK LED: Steady On indicates proper module operation. Off means the module is not functioning.
CFG LED: Lit when a module configuration has been received.
EN1 to EN4 LEDs: Indicate when the Drive Enable relays for Axis 1 to 4 are activated.
COMM Port: RJ-11 connector used to download firmware updates.
I/O Connectors: The DSM314 has four 36-pin I/O connectors (A, B, C, and D) providing analog and digital I/O circuits.
Ground Connection: The module must be grounded via the ground terminal at the bottom of the module.
This module is designed to provide precise motion control in industrial environments where high-performance servo management is required.
>> IC694DSM314 Output modules User manual (pdf)
----------
+ Ge-Fanuc Contact (for Automation Mall)