IC693PWR330
IC693PWR330 Power Supply
The IC693PWR330 is a high-capacity power supply rated for 30 watts output. It’s designed for applications that require more +5V current than the standard IC693PWR321 supply. This power supply allows the full 30 watts to be consumed from the +5V output. It operates with an input voltage range of 85-264 VAC or 100-300 VDC.
Output Voltages:
+5 VDC Output: Provides power to the main system, capable of delivering up to 30 watts.
+24 VDC "Relay" Output: Powers relay modules in the Series 90-30, up to 15 watts.
Isolated +24 VDC Output: Used internally by modules, but can also provide power externally, up to 20 watts.
Load Capacity:
The total load capacity for this power supply must not exceed 30 watts. For example:
5V output: Can supply up to 30 watts.
Isolated 24V output: Can supply up to 20 watts.
Relay output: Can supply up to 15 watts.
However, the combined total must stay within 30 watts.
Protection Features:
Overvoltage protection: Activates between 6.4V and 7V for the 5V output.
Overcurrent protection: The 5V output is limited to a maximum of 7A.
Startup and Input Power:
This power supply can draw up to 100 VA at full load (with AC input) and 50W (with DC input).
During startup, it may experience a surge current of 4A for up to 250 milliseconds.
Output Voltage Ranges:
5V output: Ranges from 5.0 VDC to 5.2 VDC (nominal 5.1V).
24V relay output: Ranges from 24V to 28V.
Isolated 24V output: Ranges from 21.5V to 28V.
Ride-Through Time:
The power supply can continue to operate for a minimum of 20 milliseconds during a power outage, meaning short interruptions won’t immediately shut down the system.
AC/DC Input Power Connections:
AC power connections: The Hot, Neutral, and Ground wires from the 120V AC power source (or L1, L2, and Ground for 240V AC) connect to the top three terminals on the terminal strip.
DC power connections: The + and - wires from the 125V DC power source connect to the top two terminals. Polarity is not important for AC/DC power supplies.
Overvoltage Protection Devices:
For all power supplies with a six-terminal board, overvoltage protection devices are connected to pin 4 on the user terminal strip. This pin is usually connected to frame ground (pin 3) with a jumper strap installed by default. If you don’t need overvoltage protection, or if it’s provided elsewhere, you can disable this feature by removing the jumper strap between pins 3 and 4. If you're performing a Hi-pot test, you must disable the overvoltage protection by removing this jumper during the test, and re-enable it afterward.
Isolated 24 VDC Output:
The bottom two terminals on the terminal strip provide the isolated +24VDC output, which can power external circuits (within the power supply’s limits).
Caution: If the isolated 24V supply is overloaded or short-circuited, the Programmable Logic Controller (PLC) will stop operating.
>> IC693PWR330 User manual (pdf)
----------
+ Ge-Fanuc Contact (for Automation Mall)