The IC693MDL750 12/24 Volt DC Negative Logic Output Module

This module provides 32 output points operating at 12/24 volts DC, arranged in four groups of eight (A1 - A8, B1 - B8, C1 - C8, D1 - D8), with two common terminals per group. It is designed for negative logic operation, meaning it sinks current from the loads to the user common or the negative power bus. The output device connects between the positive power bus and the module output.

This module is compatible with a wide range of user-supplied load devices, such as motor starters, solenoids, and indicators. The user must supply the power needed to operate the field devices.

Connections:

Connections are made through a 50-pin connector on the front of the module, which interfaces with the user's output devices.

Key Specs:

    Rated Voltage: 12/24 volts DC
    Output Voltage Range: 12 to 24 volts DC (+20%, -15%)
    Outputs per Module: 32 (four groups of eight outputs each)
    Isolation: 1500 volts between field side and logic side
    Output Current: 0.3 amps max per point, 2 amps max per common at 60°C (140°F)
    Output Voltage Drop (On-state): 0.24 volts maximum
    Off-state Leakage: 0.1 mA maximum
    On Response Time: 2 ms maximum
    Off Response Time: 2 ms maximum
    Power Consumption: 21 mA (all outputs on) from the 5-volt bus on the backplane

Wiring to Field Devices:

    Direct Method: This method uses pre-wired cables with a mating female connector on one end and stripped and tinned wires on the other. You can buy cables such as IC693CBL308 (1 meter) or IC693CBL309 (2 meters), or build your own cables if needed.
    Using a Weidmuller Terminal Block: You can purchase a Weidmuller #912263 terminal block and use it with GE Fanuc pre-wired cables, such as IC693CBL306 (1 meter) or IC693CBL307 (2 meters), which connect from the module to the terminal block mounted on a DIN rail.

This output module does not have LED indicators to show the status of the circuits. It can be installed in any I/O slot of a 5-slot or 10-slot baseplate in a Series 90-30 PLC system.

The IC693MDL750 is a negative logic output module that offers 32 output points and can control a variety of field devices, such as motor starters and solenoids. It operates at 12/24 volts DC and provides fast response times (maximum 2 ms for both on and off states). This module is a reliable solution for controlling output devices in industrial automation systems.

>> IC693MDL750 User manual (pdf)

++ Other 90-30 PLC modules

----------

+ Ge-Fanuc 2 Homepage

+ Ge-Fanuc Contact (for Automation Mall)

+ About Ge-Fanuc