IC693MDL655

The IC693MDL655 24 Volt DC Positive/Negative Logic Input Module:

This module provides 32 discrete input points divided into four isolated groups (A1 - A8, B1 - B8, C1 - C8, D1 - D8). Each group has its own common terminal, and the inputs can handle both positive and negative logic, operating at voltages up to 30V DC.

Key Details:
    Positive logic: The input device sources current from the positive power bus to the input module.
    Negative logic: The input device sinks current from the input module to the negative power bus.

When current flows into an input point, it registers as a logic 1 in the input status table (%I).

Isolation:
This module uses opto-couplers to provide isolation between the field side and the logic side (1500 volts), and also isolates the groups from one another (250 volts between groups).

LED Indicators:
The module has LEDs (labeled A1 - A8, B1 - B8, C1 - C8, D1 - D8) at the top to indicate the ON/OFF status of each input.

Power Supply:
    Power for field devices can come from either a user-supplied source or the isolated +24V DC supply from the module’s I/O connectors.
    You can use pre-wired cables (IC693CBL327 and IC693CBL328) or build your own to connect input devices to the module via 24-pin connectors on the front.

Key Specs:
    Rated Voltage: 24V DC, Positive or Negative Logic
    Input Voltage Range: 0 to 30V DC
    Inputs per Module: 32 (four groups of eight)
    Isolation: 1500V between the field and logic sides, 250V between groups
    Input Current: 7.0 mA (typical ON current at 24V DC)
    On-State Voltage: 11.5 to 30V DC
    Off-State Voltage: 0 to 5V DC
    On-State Current: Minimum 3.2 mA
    Off-State Current: Maximum 1.1 mA
    On/Off Response Time: Maximum 2 ms
Power Consumption:
        195 mA (maximum) from the +5V bus on the backplane
        224 mA (typical) from the +24V bus on the backplane or from a user-supplied 24V DC power source (all 32 inputs ON)

Wiring:

Connections are made through two 24-pin connectors located on the front of the module. The right connector is for Groups A and B, and the left connector is for Groups C and D. The user can purchase pre-wired cables or build custom cables as needed.

Application:

This module is suitable for industrial automation systems requiring multiple 24V DC inputs and works with both positive and negative logic configurations. It's designed for use with the Series 90-30 PLC system and fits into any I/O slot of a 5-slot or 10-slot baseplate.

The IC693MDL655 offers reliable performance with quick response times and high isolation, making it ideal for controlling a wide range of input devices in your PLC system.


>> IC693MDL655 User manual (pdf)

++ Other 90-30 PLC modules

----------

+ Ge-Fanuc 2 Homepage

+ Ge-Fanuc Contact (for Automation Mall)

+ About Ge-Fanuc

Reminder: IC693MDL655 and other Ge-Fanuc modules are available for sale at Otomasyon AVM. Please note that some of the devices are used products, so take this into consideration when purchasing. However, once products are out of stock, new ones will not be restocked. The information above is based on general knowledge and does not guarantee accuracy. For more detailed and precise information, it is recommended to refer to the relevant device’s user manual. 06.03.2013