120 Volt AC Output - 0.5 Amp, 16 Point (IC693MDL340)

The 120 Volt AC Output Module provides 16 output points arranged in two isolated groups, with 8 points in each group. Each group has a separate common terminal (the two commons are not tied together inside the module). This allows each group to be connected to different AC supply phases, or they can be powered from the same supply. Each group is protected with a 3-amp fuse, and an RC snubber is provided for each output to protect against transient electrical noise on the power line.

This module is capable of handling high inrush current, making it suitable for controlling inductive loads (like motors) and incandescent loads (like lamps). The AC power required to operate the loads connected to the outputs must be supplied by the user. The module requires an external AC power source.
LED Indicators:

At the top of the module, there are LED indicators that show the ON/OFF status of each output point. There are two horizontal rows of green LEDs; each row has 8 LEDs labeled from A1 to A8 and B1 to B8, representing the output status. The red LED (labeled F) is a blown fuse indicator that lights up if one of the fuses blows. A load must be connected to the blown fuse for the indicator to light.

An insert is placed between the inner and outer surfaces of the hinged door. When the door is closed, the inner surface shows the circuit wiring information, while the outer surface can be used for circuit identification. The left edge of the insert is colored red to indicate a high-voltage module.

This module can be installed in any I/O slot of a 5 or 10-slot baseplate in the Alspa C80–35 PLC system.
Technical Specifications:

    Rated Voltage: 120 volts AC
    Output Voltage Range: 85-132 volts AC, 50/60 Hz
    Outputs per Module: 16 (two groups, each with 8 outputs)
    Isolation: 1500 volts RMS between the field side and logic side; 500 volts RMS between groups
    Output Current: 0.5 amps maximum per point, 3 amps maximum per group
    Inrush Current: 20 amps maximum for one cycle
    Minimum Load Current: 50 mA
    Output Voltage Drop: 1.5 volts RMS
    Off-State Leakage Current: 2 mA maximum at 120 volts AC
    On Response Time: 1 ms maximum
    Off Response Time: 1/2 cycle maximum
    Power Consumption: 315 mA (all outputs ON) from the 5-volt bus on the backplane

For additional technical details and wiring information, please refer to the product datasheet.

>> IC693MDL340 User manual (pdf)

++ Other 90-30 PLC modules

----------

+ Ge-Fanuc 2 Homepage

+ Ge-Fanuc Contact (for Automation Mall)

+ About Ge-Fanuc