120/240 Volt AC Output - 2 Amp, 8 Point (IC693MDL330)

This 120/240 Volt AC Output Module provides 2 amp AC output and is designed for use with the Alspa C80–35 Programmable Logic Controller (PLC). The module features a total of 8 output points, divided into two isolated groups, with each group containing 4 outputs. Each group has its own separate common, and these commons are not tied together inside the module. This allows each group to be connected to different phases of the AC supply, or they can be powered from the same supply.

Each group is protected by a 5-amp fuse for each common, and an RC snubber is provided for each output to protect against transient electrical noise on the power line. The module supports a high degree of inrush current (up to 10 times the rated current), making it suitable for controlling inductive loads (such as motors) and incandescent loads (such as lamps).

This module requires AC power to operate the loads connected to the outputs, and it cannot be used with a DC power source.
LED Indicators:

At the top of the module, there are LED indicators that display the ON/OFF status of each output point. There are two horizontal rows of green LEDs, labeled A1 to A8 for output status. A red LED is provided as a blown fuse indicator, which lights up if any of the fuses blow. An insert is placed between the inner and outer surfaces of the hinged door. When the door is closed, the inside of the module shows circuit wiring information, while the outside surface can be used for circuit identification. The left edge of the insert is colored red to indicate that this is a high-voltage module.

This module can be installed in any I/O slot of a 5 or 10-slot baseplate in the Alspa C80–35 PLC system.
Technical Specifications:

    Rated Voltage: 120/240 volts AC
    Output Voltage Range: 85-264 volts AC, 50/60 Hz
    Outputs per Module: 8 (two groups, each with 4 outputs)
    Isolation: 1500 volts RMS between the field side and logic side; 500 volts RMS between groups
    Output Current: Maximum 2 amps per point, 4 amps maximum per group at 40°C (104°F)
    Inrush Current: 20 amps maximum for one cycle
    Minimum Load Current: 100 mA
    Output Voltage Drop: Maximum 1.5 volts
    Off-State Leakage Current:
        3 mA maximum at 120 volts AC
        6 mA maximum at 240 volts AC
    On Response Time: 1 ms maximum
    Off Response Time: 1/2 cycle maximum
    Power Consumption: 160 mA (all outputs ON) from the 5-volt bus on the backplane

For additional technical details and wiring information, please refer to the product datasheet.

>> IC693MDL330 User manual (pdf)

++ Other 90-30 PLC modules

----------

+ Ge-Fanuc 2 Homepage

+ Ge-Fanuc Contact (for Automation Mall)

+ About Ge-Fanuc