IC693CHS391

GE Fanuc IC693CHS391 Expansion Baseplates

Expansion baseplates are used to extend the capacity of a PLC system, allowing for additional modules to be connected and used alongside the main CPU baseplate. These baseplates provide flexibility in expanding the system's I/O and capabilities, but they come with certain limitations and rules for proper integration.
Key Features of IC693CHS391 Expansion Baseplates:

   Cable Length Limitation:
        The total length of cable interconnecting the expansion baseplates and the CPU baseplate cannot exceed 50 feet (15 meters). This ensures proper communication and power distribution across the system.

   Dependent on a CPU:
        An expansion baseplate cannot operate independently. It must be connected to a system that includes a CPU, which can either be housed in a PLC or a Personal Computer equipped with a Personal Computer Interface Card. For more details on interfacing with a personal computer, refer to Chapter 11 of the relevant manual.

   Maximum Number of Expansion Baseplates:
        The maximum number of expansion baseplates allowed in a system depends on the CPU type:
           CPUs 331, 340, 341: Support up to 4 expansion baseplates.
           CPUs 350 and higher: Support up to 7 expansion baseplates.

   I/O Bus Expansion Connector:
        Each expansion baseplate is equipped with a 25-pin female D-type I/O Bus Expansion Connector located on the right side. This connector allows the baseplate to be linked with other baseplates for seamless communication.

   Available Versions:
        Expansion baseplates are available in two versions:
           5-slot version (IC693CHS398)
           10-slot version (IC693CHS392)

   Module Support:
        While expansion baseplates support most I/O and option modules, there are exceptions:
            The following intelligent option modules cannot be mounted in expansion baseplates and must be installed in a CPU baseplate:
               PCM (Programmable Coprocessor Module)
               ADC (Analog-to-Digital Converter)
               BEM330 (Bus Expansion Module)
               CMM (Communications Module)
            All other I/O and option modules can be mounted in any type of baseplate, including expansion or remote baseplates.

   Grounding Requirement:
        All expansion baseplates must be connected to a common ground to ensure system stability and avoid grounding issues. Details on proper grounding procedures can be found in the Installation chapter of the manual.

   Physical Size and Compatibility:
        Expansion baseplates have the same physical size and use the same type of power supplies as Remote baseplates. They also support the same I/O and option modules, providing consistency and compatibility across the system.

   Rack Number Selection:
        Each expansion baseplate is equipped with a Rack Number Selection DIP switch, allowing users to assign a unique rack number for the baseplate within the system. This ensures proper addressing and identification of each baseplate by the CPU.

>> IC693CHS391 User manual (pdf)

++ Other 90-30 PLC modules

----------

+ Ge-Fanuc 2 Homepage

+ Ge-Fanuc Contact (for Automation Mall)

+ About Ge-Fanuc

Reminder: IC693CHS391 and other Ge-Fanuc modules are available for sale at Otomasyon Mall. Please note that some of the devices are used products, so take this into consideration when purchasing. However, once products are out of stock, new ones will not be restocked. The information above is based on general knowledge and does not guarantee accuracy. For more detailed and precise information, it is recommended to refer to the relevant device’s user manual. 06.03.2013