IC693CBL328
IC693CBL328 Overview and Connection Details
Faceplate Connector to Terminal Block Connector: This cable features a 24-pin connection.
Connection Method: It connects to two male 24-pin connectors (Fujitsu FCN–365P024–AU) located on the front of the module.
Wiring: The wiring to field devices is accomplished using a cable that has a female connector on one end and stripped and tinned wires on the other end.
You can purchase pre-wired cables under catalog numbers IC693CBL327 and IC693CBL328, or you can build your own cables. For more details, refer to Appendix B.
Installation Guidelines:
TTL Wiring Practices: When installing this module, standard TTL wiring practices should be followed.
Noise Immunity: The length of the I/O control lines connected to the module must not exceed 30 meters, as signal attenuation limits the wiring length.
Pin Layout and Connections:
The detailed pin layout looks like this:
I25, I27, I29, I31, COM, NC, 5V OUT, NC, continuing with other pins like I24, I22, I20, I18 in a structured layout.
Positive and negative terminals are represented by -- + and + --.
Isolation Specifications:
If the 24V OUT pin is used to connect input devices in the field, the isolation specification changes:
Field to Backplane (optical) and frame ground: 50 VAC continuous, 500 VAC for 1 minute.
TTL Wiring and Logic Configuration:
For compatibility with TTL outputs, the negative logic configuration is recommended, as shown in the wiring diagram.
>> IC693CBL328 cables User manual (pdf)
----------
+ Ge-Fanuc Contact (for Automation Mall)