IC693CBL317

The IC693CBL317 is a special 10 feet (3 meters) long APM I/O cable that connects one of the 24-pin connectors on an APM module to the terminal block. This cable is similar to the IC693CBL311, but its drain shield wire is brought outside of the connector through an 8-inch external shield pigtail, which improves the module’s noise immunity. Each APM module requires two cables for operation.


APM Modules Supported:

    IC693APU301
    IC693APU302

Function of the Cable:

This I/O Interface Cable consists of a 24-pin I/O connector, the cable itself, and a 25-pin D-type terminal block connector. It is used to connect Power Mate APM Modules (IC693APU301 and IC693APU302) to drives and machines. These APM modules have two male 24-pin connectors on the front, and two of these cables are required to connect the module to the drive and machine.

    IC693CBL311 is a 10 feet (3 meters) long cable.
    IC693CBL319 is a 3 feet (1 meter) long cable.
    IC693CBL317 (the one described here) is similar to the above but includes the 8-inch external shield pigtail for improved noise immunity.

Improved Noise Immunity:

The IC693CBL317 and IC693CBL320 cables have their drain shield wire disconnected from pin B12 and routed externally via an 8-inch pigtail, enhancing the Power Mate APM’s ability to resist electrical noise. This makes these cables better suited for environments where electromagnetic interference (EMI) is a concern.


Wiring and Installation:

Each connector on the module is typically connected by a short I/O Interface cable to a terminal block. The cable that connects the I/O connector to an external terminal block can be shortened to meet installation requirements. For more details on wiring, refer to:

    Manual GFK-0840 (standard mode)
    Manual GFK-0781 (follower mode)

These manuals provide further information about APM terminal blocks and the required wiring configurations.

+  IC693CBL317 User manual (pdf)

>> Ge fanuc 90-30 User manual (pdf)

++ Other 90-30 PLC modules

----------

+ Ge-Fanuc 2 Homepage

+ Ge-Fanuc Contact (for Automation Mall)

+ About Ge-Fanuc

Reminder: IC693CBL317 and other Ge-Fanuc modules are available for sale at Otomasyon Mall. Please note that some of the devices are used products, so take this into consideration when purchasing. However, once products are out of stock, new ones will not be restocked. The information above is based on general knowledge and does not guarantee accuracy. For more detailed and precise information, it is recommended to refer to the relevant device’s user manual. 06.03.2013 

"Please note: The user manuals, commissioning suggestions, error codes, and solution recommendations provided on this page are not binding. The information and documents above are open to and even in need of improvement. As the Otomasyon Mall Community, we gladly welcome your suggestions and contributions. If you have field experience and insights on ease of use, please do not hesitate to share them with us."