Gemo LT102HT Temperature and Humidity control 
- We have been selling Gemo products on our website since 2013.

 Input supply voltage 220v (24 volt supply must be specified with order)
 Input type ; Own special sensor >
 Output type ; relay (must be specified in order for SSR)

- Size : 35x77mm
- Panel Section : 29x71mm - Display : 3 Digits 7 Segments
- Sensor Type: Special Sensor (GM-HT-01)
- Measuring Scale: -19,9..+80,0 oC, 5 .. 95%RH
- Sensitivity : ± 0.1 oC, ± 1%RH
- Accuracy: ± 1% (oC), ± 3% (%RH); of full scale
- Control Form: ON-OFF
- Heating / Cooling : Ht (heating), CL (cooling); optional
- Humidity Function: lo (dehumidification), hi (dehumidification); selectable
- oC Output: Relay (NO + NC), 250VAC, 2A, Resistive load

- %RH Output : Relay (NO), 250VAC, 2A, Resistive load
- Supply Voltage: 100..240VAC, 50-60Hz or 24VDC/AC.
- Power Consumption : < 6VA - Relative Humidity : 80% up to 30oC, then linearly decreasing 50% at 50oC (non-condensing)
- Operating altitude: < 2000 m
- EMC : EN 61000-6-1, EN 61000-6-3 (Light industrial environment only) It can work in the panel with speed controllers.
- Safety: EN 61010-1; Pollution degree 1, measurement class I (Light industrial environment only, double/reinforced insulation, non-conductive pollution)
- Protection Class: IP20; According to EN 60529
- Operating Temperature: 0 .. 50 oC
- Storage Temperature : -10oC .. 60oC (without icing) - Weight : < 0.5 kg
- Keypad : Micro switch

WARNING: Connect the cables of the temperature / humidity sensor properly according to the cable color codes specified on the device label when the device is powered off, otherwise permanent sensor / device failure may occur.

- Microprocessor based temperature and humidity controller
- Measurement and control scale: -19,9oC ... +80,0oC, 5 .. 95 %RH
- ON-OFF control form
- Separate control outputs for temperature and humidity
- Heating and Cooling function; optional
- Dehumidification / humidity increase function; optional
- Possibility to select lower and upper limits separately for Temperature and Humidity SET values
- Hysteresis adjustment possibility for Temperature and Humidity SET values ​​separately
- Built-in adjustable delay timer before commissioning for cooling function (compressor protection feature)
- Possibility to add “Offset” to the measured Temperature and Humidity value separately
- Possibility to show selectable parameters
- Password protected
- High precision, accuracy
- Ability to keep program and control parameters in memory - Gemo price list >

- Gemo LT102ht User Manual (pdf) -

+ Gemo Price list

+ Gemo Contact

++ Gemo electronic main page

+ Control devices main page  

---------