IC693CBL313
IC693CBL313 (8 meters / 25 feet) and IC693CBL314 (15 meters / 50 feet) Expansion Cables
General Cable Usage:
The IC693CBL313 and IC693CBL314 cables are used to daisy-chain up to seven expansion backplanes to the main backplane in an I/O bus system.
These cables can also be used to provide connection points for custom point-to-point connections, often utilizing the IC693CBL300 for this purpose.
Termination Requirements:
These cables do not have built-in termination, so the last backplane in the expansion chain must be properly terminated.
A Terminator Plug (IC693ACC307) is used to terminate the last expansion backplane in the system, ensuring stable system operation.
The total length of the cables from the universal backplane to the last expansion backplane should not exceed 15 meters (50 feet). Exceeding this length can cause the system to malfunction.
Cable Specifications:
Cable Type: Belden 8107 (no substitutes)
Construction: Overall braid over foil shield, twisted-pair
Voltage Rating: 30 volts
Temperature Rating: 80°C (176°F)
Wire Gauge: 24 AWG (0.22 mm²) tinned copper
Nominal Impedance: 100 Ohms
Velocity of Propagation: 70%
Connector Types:
Crimp Plug: Amp 207464–1; Pin Male Connector: Amp 66506–925
Solder Plug: Amp 747912–2
Crimp Receptacle: Amp 207463–2; Pin Female Connector: Amp 66504–925
Connector Shell Kit: Amp 745833–5 (metal-plated plastic with nickel over copper)
Pin Assignments and Signals: The cables carry various signals with the following pin-to-pin connections:
Pin 16 & 17: DIODT (I/O Serial Data, Positive & Negative)
Pin 24 & 25: DIOCLK (I/O Serial Clock, Positive & Negative)
Pin 20 & 21: DRSEL (Remote Select Signal, Positive & Negative)
Pin 12 & 13: DRPERR (Parity Error, Positive & Negative)
Pin 8 & 9: DRMRUN (Remote Run Signal, Positive & Negative)
Pin 2 & 3: DFRAME (Cycle Frame, Positive & Negative)
Pin 1: FGND (Frame Ground for Cable Shield)
Pin 7: 0V (Logic Ground)
Cable Assembly: For custom-length cables, the best noise immunity is achieved by using a metalized connector cover that ensures contact with the braided and foil shielding across the entire length of the cable.
Steps for Cable Assembly:
Strip approximately 5/8 inch of insulation to expose the shield.
Place a split-ring ferrule over the cable insulation.
Fold the shield back over the ferrule and insulation.
Secure the metal hood over the folded shield and clamp it tightly.
Test the cable with an ohmmeter to ensure continuity between both connector shells.
Summary:
The IC693CBL313 and IC693CBL314 cables are essential for connecting expansion backplanes to the main backplane.
Proper termination of the last backplane is required, and the total cable length should not exceed 15 meters.
Correct assembly and termination are critical for maintaining signal integrity and ensuring stable system performance.
>> IC693CBL313 Data cables User manual (pdf)
----------
+ Ge-Fanuc Contact (for Automation Mall)