IC693CBL311

The IC693CBL311 is a 10 feet (3 meter) long APM I/O cable used to connect one of the 24-pin connectors on a module to the terminal block. Two of these cables are required per module. This cable is specifically designed for use with the following APM modules:

    IC693APU301
    IC693APU302

APM Cables Overview:

These cables consist of a 24-pin I/O connector, a cable, and a 25-pin D-type terminal block connector. The following APM cables are available:

    IC693CBL311: 10 feet (3 meters)
    IC693CBL319: 3 feet (1 meter)
    IC693CBL317: 10 feet (3 meters) with an 8” external shield pigtail
    IC693CBL320: 3 feet (1 meter) with an 8” external shield pigtail

If custom cable lengths are needed, 24-pin I/O cable connectors are available in different kits (solder eyelet receptacle, crimp wire receptacle, and IDC/ribbon receptacle). The terminal block is typically a Weidmuller RD25 910648 or an equivalent model compatible with the I/O cables.

I/O Interface Cables for Power Mate APM Modules:

These I/O interface cables are used to connect Power Mate APM modules to drives and machines. Each Power Mate APM module (such as the IC693APU301 and IC693APU302) has two male 24-pin connectors on the front. Two I/O interface cables are required for each module to handle connections to and from the drive and machine.

IC693CBL311 cable is 10 feet (3 meters) long, while the IC693CBL319 is 3 feet (1 meter) long. These cables are designed for ease of connection between the module and terminal blocks.

Noise Immunity with Shielded Pigtail:

For improved noise immunity, there are versions of the cable, such as the IC693CBL317 (10 feet) and IC693CBL320 (3 feet), where the drain shield wire is disconnected from pin B12 and routed outside the cable housing via an 8-inch pigtail.

Wiring and Installation:

For easier wiring to the drive and machine, each connector on the APM module typically connects to a terminal block using these I/O interface cables. The cable lengths can be shortened if necessary to fit specific installation requirements. For more details, refer to:

    Manual GFK-0840 (standard mode)
    Manual GFK-0781 (follower mode)

These manuals provide further information on wiring and the configuration of APM terminal blocks.

By using the appropriate cable, such as IC693CBL311, IC693CBL319, IC693CBL317, or IC693CBL320, you ensure proper connection and signal integrity between the APM modules and their connected devices.



+  IC693CBL311 User manual (pdf)

>> Ge fanuc 90-30 User manual (pdf)

++ Other 90-30 PLC modules

----------

+ Ge-Fanuc 2 Homepage

+ Ge-Fanuc Contact (for Automation Mall)

+ About Ge-Fanuc

Reminder: IC693CBL311 and other Ge-Fanuc modules are available for sale at Otomasyon Mall. Please note that some of the devices are used products, so take this into consideration when purchasing. However, once products are out of stock, new ones will not be restocked. The information above is based on general knowledge and does not guarantee accuracy. For more detailed and precise information, it is recommended to refer to the relevant device’s user manual. 06.03.2013 

"Please note: The user manuals, commissioning suggestions, error codes, and solution recommendations provided on this page are not binding. The information and documents above are open to and even in need of improvement. As the Otomasyon Mall Community, we gladly welcome your suggestions and contributions. If you have field experience and insights on ease of use, please do not hesitate to share them with us."