IC694MDL632

IC694MDL632: 125 Volt DC Positive/Negative Logic Input Module

The IC694MDL632 is a 125-volt DC input module that provides 8 input points divided into two isolated groups, each with 4 input points. Each group has its own separate common terminal (the commons are not internally connected within the module). These groups can be wired for either positive or negative logic. When current flows into an input point, it registers as a logic "1" in the input status table (%I). The module is compatible with a wide range of input devices, including pushbuttons, limit switches, and electronic proximity switches.

Users must supply power to operate field devices. The module features 8 green LEDs to indicate the ON/OFF status of points 1 through 8. Red bands on the label show that the IC694MDL632 is a high-voltage module. It can be installed in any I/O slot of an RX3i system.
Technical Specifications:

   Rated Voltage: 125 volts DC (Positive or Negative Logic)
   Input Voltage Range: 0-150 volts DC
   Inputs per Module: 8 (two groups of four inputs each)
   Isolation:
       Field to Backplane and Frame Ground: 250 VAC continuous, 1500 VAC for one minute
       Group to Group: 250 VAC continuous, 1500 VAC for one minute
   Input Current: Typically 4.5 mA
   Input Characteristics:
       On-state Voltage: 90-150 volts DC
       Off-state Voltage: 0-30 volts DC
       On-state Current: Minimum 3.1 mA
       Off-state Current: Maximum 1.1 mA
       On Response Time: Typically 7 ms
       Off Response Time: Typically 7 ms
   Power Consumption:
        40 mA from the 5-volt bus on the backplane
        36 mA (typical) from the user input supply (with all inputs ON)

Input Points vs. Temperature:

The number of input points that can be ON simultaneously depends on the ambient temperature. For example, as the temperature increases (above 40°C), the number of active inputs decreases.
Wiring:

   Terminals:
       Terminals 2, 4, 6, 8, 12, 14, 16, 18: For input connections.
       Terminal 10: The common return for inputs 1-4.
       Terminal 20: The common return for inputs 5-8.

The IC694MDL632 is an 8-point input module that operates at 125 volts DC and supports both positive and negative logic configurations. Designed for high-voltage environments, it provides reliable input handling for a variety of devices. With two isolated groups, each group can be configured separately, offering flexibility and safety for industrial applications.

>> IC694MDL632 input modules User manual (pdf)

++ Other 90-30 PLC modules

----------

+ Ge-Fanuc 2 Homepage

+ Ge-Fanuc Contact (for Automation Mall)

+ About Ge-Fanuc

Reminder: GE Fanuc IC694MDL632 input modules and other Ge-Fanuc modules are available for sale at Otomasyon Mall. Please note that some of the devices are used products, so take this into consideration when purchasing. However, once products are out of stock, new ones will not be restocked. The information above is based on general knowledge and does not guarantee accuracy. For more detailed and precise information, it is recommended to refer to the relevant device’s user manual. 06.03.2013 

"Please note: The user manuals, commissioning suggestions, error codes, and solution recommendations provided on this page are not binding. The information and documents above are open to and even in need of improvement. As the Otomasyon Mall Community, we gladly welcome your suggestions and contributions. If you have field experience and insights on ease of use, please do not hesitate to share them with us."