6ES7 195-1JA00-0XA0

Siemens automation › SIMATIC S7 › Siemens ET 200 › 6ES7195-1JA00-0XA0

Siemens 6ES7 195-1JA00-0XA0 ET 200M Bus Cover Set

6ES7 195-1JA00-0XA0 is an accessory set for Siemens ET 200M, containing 4 backplane bus covers and 1 bus module end cover. Within Siemens ET 200 distributed I/O systems, it provides covers for ET 200M stations assembled with active bus modules. This order number identifies the cover set; it does not include an active bus base or an electronic I/O module.

Where do the two cover types fit?

The backplane bus cover fits an unoccupied module slot. The bus module end cover closes the last bus module in the assembly. The Siemens ET 200M manual identifies these as separate locations. When reviewing ET 200 connection modules, distinguish an empty module slot from the right-hand end of the station; each location requires the appropriate cover.

A set contains 4 + 1 pieces, rather than five identical covers. A station missing only its end cover has a different maintenance requirement from one with several unoccupied slots. Marking empty slots and the final bus module on a cabinet photograph helps document the ET 200 system arrangement and establish the required quantities.

Distinguishing covers from active bus modules

This accessory supplies covers; it does not independently enable module replacement during operation. That capability must be assessed with the station interface, active bus modules and mounting arrangement. When researching PROFIBUS and PROFINET interfaces, do not interpret this cover order number as an interface or communication converter.

The set also does not replace ET 200 terminal blocks or field wiring connectors. Recording bus bases, covers, terminals and interfaces as separate items makes the scope of maintenance materials clearer. The Siemens data sheet specifies an approximate weight of 14 g for this accessory.

Five checks before selection or maintenance

1. Complete order number: Confirm that the required item is 6ES7195-1JA00-0XA0. Avoid selecting solely by the description “ET 200 cover”; record both the station family and the intended fitting location.

2. Cover type and quantity: Count empty slots and station ends separately. Mark removed modules, reserved positions and existing covers on a cabinet photograph to prepare the materials list.

3. Station arrangement: Compare the installed positions of ET 200 digital input modules, ET 200 digital output modules and ET 200 analog input modules with the current hardware project. A covered slot should not be treated as the physical equivalent of an electronic module configured in the project.

4. Mechanical condition: Inspect the cover clips, seating surfaces and mating features on the bus base. Check the correct type and orientation instead of forcing a cover into place; record cracked or missing parts for maintenance.

5. Maintenance scope: Identify the ET 200 power supply modules and power distribution components from the cabinet drawings before intervention. If the work expands from checking covers to removing a bus base or module, follow the Siemens maintenance procedure for that component.

Editor's note: Record requirements as “empty-slot cover” and “bus module end cover”, rather than a single total quantity. A photograph showing where each of the two parts belongs can save time when reassembling a station that has been dismantled.

Manuals and PDF documentation

Use the Siemens ET 200 PDF documentation and user manuals page to explore the relevant ET 200M documents. The mechanical configuration, active bus module installation and order-number sections of ET 200M Operating Instructions explain the application of this set. Check the document against the hardware version installed in your station.

Related topics

Power and connections: Power supply modules · Terminal blocks · Connection modules · Power distribution modules

Explore the station: About ET 200 · Communication interfaces · ET 200 manuals

Otomasyon AVM | Siemens:
Siemens main menu  |  Siemens S7 PLC  |  SIMATIC S7  |  ET 200 modules