6ES5 710-8MA41
Siemens Main Menu › SIMATIC S7 › ET 200 Modules
Siemens 6ES5 710-8MA41 — 35 × 15 mm Mounting Rail, 2 Metres
6ES5 710-8MA41 is a 2-metre SIMATIC standard mounting rail for securing compatible devices inside a control cabinet. Siemens also lists it in the ET 200S and ET 200SP documentation for ET 200 distributed I/O systems. The 6ES5 prefix does not restrict it to S5 installations. This is a mechanical support, not an electronic module or communication device.
Technical characteristics
Order number: 6ES5710-8MA41. Length: 2000 mm. Profile size: 35 × 15 mm. Material: Steel. Finish: The Siemens product data sheet specifies galvanic/electrolytic galvanizing. The 35 mm dimension describes the profile width, not the rail length.
Its role in an ET 200 station
The rail provides mechanical support for compatible ET 200 terminal bases and connection modules. Fitting electronic modules into their bases and making the station's electrical connections are separate tasks. When reviewing the ET 200 system architecture, distinguish the rail from the terminal base and backplane bus: the mounting rail does not replace the data bus.
Include the space occupied by PROFIBUS and PROFINET interface modules in the layout. For digital input modules and digital output modules, account for base widths, station termination and service clearance. A 2-metre rail does not mean that one station can extend to 2 metres; the relevant system manual defines the station limits.
Five checks before selection and installation
1. Profile compatibility: Confirm that each device accepts a 35 × 15 mm rail. This profile has a different depth from a 35 × 7.5 mm rail; check clearance to the cabinet door and cable ducts.
2. Usable length: Allow for end stops, mounting hardware and maintenance space in addition to device widths. For a used rail that has been cut, measure the actual piece instead of relying on the order number's nominal 2000 mm length.
3. Fixing and condition: Check straightness, retaining edges and surface finish. Select fixing intervals according to device loading, vibration and the system manual. Cut or drill away from electronics and remove all burrs and metal debris.
4. Grounding and shielding: Screwing a metal rail into a cabinet does not by itself establish a suitable PE connection in every installation. Mounting-plate finish and contact arrangements matter. For cabinets containing analog input and measurement modules, complete shield connections according to the device instructions.
5. Power connections: Check ET 200 power supply modules and power distribution components against their respective wiring diagrams. The rail is neither a 24 V supply line nor an AUX1 bus. Keep mechanical support separate from electrical potential distribution.
Other lengths in the same range
6ES5710-8MA11: 483 mm; 6ES5710-8MA21: 530 mm; 6ES5710-8MA31: 830 mm; 6ES5710-8MA41: 2000 mm. Specify the complete order number and required actual length when ordering.
Editor's Note
A mounting rail may look simple, but a bent section or damaged edge can prevent otherwise sound terminal bases from locking correctly. When buying used, check actual length, straightness and retaining edges as well as the order number. For a new layout, dimension the module sequence and service clearances before cutting the rail.
PDF manuals and installation documents: Consult Siemens ET 200 user manuals and PDF documents for the installed subfamily. Relevant references include the installation chapter in the ET 200S manual A5E00515771-06 and the installation and accessories sections in the ET 200SP manual A5E03576849-AF. Use the 6ES5710-8MA41 product data sheet for dimensions and material specifications.
Related Topics
Terminal Blocks · Connection Modules · Power Distribution Modules · Safety Modules
Otomasyon AVM
Siemens Main Menu ·
SIMATIC S7 ·
ET 200 Modules ·
ET 200 PDF Manuals ·
PLC and HMI