6ES7 132-4BB00-0AA0
Siemens automation › SIMATIC S7 › Siemens ET 200 › 6ES7132-4BB00-0AA0
Siemens 6ES7 132-4BB00-0AA0 — ET 200S 2 DO Standard
The 6ES7 132-4BB00-0AA0 is an ET 200S, 2 DO Standard, 24 V DC / 0.5 A digital output module in the Siemens ET 200 family. When selecting ET 200 digital output modules, consider the channel count, load current and complete order number together.
Electrical specifications
Channel current: 0.5 A; module total: 1 A. Width: 15 mm. Short-circuit protection: provided; diagnostic functions: none. Green LEDs indicate channel status. Do not parallel outputs to increase current capacity.
Choosing the terminal base
TM-E15S24-01 is one compatible base shown in the manual. DO0: terminal 1; DO1: terminal 5. Compare ET 200 terminal blocks against the installed base label and wiring diagram. Similar-looking ET 200 connection modules do not necessarily share terminal assignments. When changing to a module with more outputs, check every terminal function before retaining the existing wiring.
BB00, BB01 and High Feature versions
Siemens' SIMOTION compatibility list identifies 6ES7132-4BB01-0AA0 as the successor to this model. 6ES7132-4BB00-0AB0 is the High Feature version. When considering an alternative, compare interface support, hardware configuration and application requirements rather than relying on similar order numbers.
Power and station planning
When assessing ET 200 power supply modules, include all loads in the same supply group. Mark the common supply and return connections made through ET 200 power distribution components on the panel drawings. Two loads drawing 0.3 A each require a combined 0.6 A; loads on other modules must be added separately.
When documenting the ET 200 station configuration, record the complete order numbers and firmware versions of the PROFIBUS and PROFINET interfaces. Match feedback from the controlled equipment to the corresponding ET 200 digital input modules. If an output triggers a counter or an ET 200 function module, include power-up behaviour in the functional test.
Five checks before selection or replacement
1. Complete order number: Verify 6ES7132-4BB00-0AA0 on the label; distinguish the AA0 and AB0 suffixes.
2. Load requirements: Check steady-state current, starting current and simultaneous operation. Matching the nominal voltage alone is insufficient.
3. Terminal arrangement: Compare the base number, field cable identification and common returns with the existing project.
4. PLC project: Check the hardware catalogue selection and output addresses; retain a current project backup before replacement.
5. Field test: Operate each output separately. Compare LED status, voltage at the load and the equipment's actual response.
Editor's note: Applying the power module's 24 V supply through a mechanical contact can produce an approximately 50 µs “1” at the output, depending on the circuit. Consider this when investigating extra counts during power-up.
Manuals and PDF documents
For Siemens ET 200 PDF and user manuals, consult ET 200S — EWA-4NEB780602402-09, section 12.11. When assessing a replacement, match the installed device's complete order number to the model covered by the document.
Related topics
Power and connections: Power supply modules · Terminal blocks · Connection modules · Power distribution modules
Explore the station: About ET 200 · Communication interfaces · ET 200 manuals
Otomasyon AVM | Siemens:
Siemens main menu | Siemens S7 PLC | SIMATIC S7 | ET 200 modules