6ES7 132-0BL00-0XB0

Siemens automation › SIMATIC S7 › Siemens ET 200 › 6ES7132-0BL00-0XB0

Siemens 6ES7 132-0BL00-0XB0 — ET 200B 32 Digital Output Block

The 6ES7 132-0BL00-0XB0 is an ET 200B electronic block with 32 outputs, 24 V DC / 0.5 A, within the Siemens ET 200 family. When selecting ET 200 digital output modules, check the series as well as the order number; ET 200B, ET 200L and ET 200S components should not be assumed to share the same connection system.

Eight-channel group current limit

The outputs form four groups of eight. Limits are 0.5 A per channel and 2 A total per group. For example, eight loads drawing 0.3 A each in one group require 2.4 A, exceeding the group limit. A suitable individual channel current is insufficient; calculate simultaneous loads separately for each group.

Terminal base and separate supplies

Compatible bases include TB2/DC, TB2-4/DC and TB4/DC. Record the complete installed base number when selecting ET 200 terminal blocks. When assessing ET 200 connection modules, establish compatibility with the electronic block before comparing terminal counts.

L1+–L4+ supply the output groups; L5+/M5 supplies the electronics. The L and M groups are not internally bridged together. When reviewing ET 200 power supply modules and ET 200 power distribution components, trace these separate supply points on the panel drawings. Operating electronics do not establish that every load group has power.

Addressing and communication checks

Terminals 1–8: Q0; 9–16: Q1; 17–24: Q2; 25–32: Q3; each group covers outputs .0–.7. Distinguish these local markings from absolute PLC program addresses. When documenting the ET 200 station configuration, record the starting address, field cable numbers and equipment names together.

When comparing network arrangements on the PROFIBUS and PROFINET interfaces page, refer to this station's existing DP master configuration. Compare the station address, device description and communication settings with the project backup. Match output commands to feedback from ET 200 digital input modules and include relevant process readings from ET 200 analog input modules in the fault record.

Five checks before selection or replacement

1. Product identity: Verify the complete 6ES7132-0BL00-0XB0 number. Do not assume that a 0BL01 or 1BL00 version is directly interchangeable.

2. Load distribution: Check each output current and the combined simultaneous load in its eight-channel group; consider starting currents too.

3. Base and wiring: Inspect the electronic block and terminal base together. Check for loose connections, corrosion and incorrect bridging.

4. Project match: Record the station address, output addresses and device description. Back up the working project before making changes.

5. Functional test: Test outputs individually, then under the application's simultaneous operating conditions. Monitor supply voltage under load and the actual field response.

Editor's note: If several adjacent outputs stop operating together, check their shared supply group, fuse and return connection before replacing the electronic block. When a panel works with one load but develops problems as several loads switch on, investigate group current and voltage drop.

Manuals and PDF documents

For Siemens ET 200 PDF and user manuals, the model-specific reference is ET 200B, EWA 4NEB 812 6089-02b, section 8.1.8. Check the manual edition; do not apply the technical table for a different block with a similar order number.

Related topics

Power and connections: Power supply modules · Terminal blocks · Connection modules · Power distribution modules

Explore the station: About ET 200 · Communication interfaces · ET 200 manuals

Otomasyon AVM | Siemens:
Siemens main menu  |  Siemens S7 PLC  |  SIMATIC S7  |  ET 200 modules