Delta VFD-F Manuals

Hi everyone,
Delta VFD-F is a variable frequency drive (VFD) specifically designed for controlling the speed of fans and pumps. The "F" in the model name stands for "fan-pump." This type of VFD is used to control the speed of an electric motor, which in turn controls the speed of the fan or pump connected to it. This allows for precise control of the airflow or fluid flow, which can improve efficiency, reduce energy consumption, and extend the lifespan of the fan or pump.
The frequency command source setting (Factory Setting: 00) determines where the drive will receive its frequency command from. The options include: via the keypad, via analog input AVI, via analog input ACI1, via analog input ACI2, via RS485 serial communication, or via an external reference.
The operation command source setting (Factory Setting: 00) determines where the drive will receive its operation command from. The options include: controlled by the digital keypad, controlled by the external terminals with keypad STOP enabled, controlled by the external terminals with keypad STOP disabled, controlled by the RS-485 communication interface with keypad STOP enabled, or controlled by the RS-485 communication interface with keypad STOP disabled.
Both settings can be used to customize the VFD-F's operation to fit the specific application and requirements.
The faults listed include: an abnormal increase in current, DC bus voltage exceeding its maximum allowable value, excessive heat detected by the temperature sensor, DC bus voltage falling below its minimum value, excessive drive output current, internal electronic overload trip, motor overload, GFF hardware error, CC hardware error, OC hardware error, OV hardware error, OH hardware error, communication error, over-current during acceleration, over-current during deceleration, and over-current during steady state operation.
The corrective actions listed for each fault include checking for specific causes such as wiring connections, input voltage, voltage transients, motor regeneration, brake power, ventilation, torque compensation, output capacity, and communication protocol. If the problem persists, the drive should be sent back to the manufacturer for further diagnosis and repair.
VFD-F
+ Delta VFD-F User manual (pdf)
++ Brake resistor value >>
-----------------