Delta UC-EMC003-02A
Delta UC-EMC003-02A
Delta UC-EMC003-02A is a shielded Ethernet/EtherCAT cable with RJ45-to-RJ45 connectors and a nominal length of 0.3 metres (300 mm). It can be considered for network connections between nearby cabinet devices. Verify both devices' port functions, supported protocol and cable route together.
The 2019 manufacturer cable guide identifies the UC-EMCxxx-02A family with a green cable and ETG certification. For this model, 003 means 0.3 metres, rather than 3 metres. Review other lengths and suffixes through Delta EtherCAT cables.
Port and application compatibility
The AH catalogue lists UC-EMC003-02A with Delta AH08EMC-5A, Delta AH10EMC-5A and Delta AH20EMC-5A controllers. For Delta AH motion controllers, verify the separate roles of the EtherCAT and Ethernet ports. The cable does not add a protocol that the device itself does not support.
For the other device, review EtherCAT drive families such as Delta ASDA-A2-E. Within Delta ASDA-B3, identify the EtherCAT-capable -E variant separately. Do not assume common cable compatibility across Delta servo drives without checking the complete drive code and port drawing.
The guide's EtherCAT drawing identifies 1: TX+, 2: TX−, 3: RX+, 6: RX−. Check the drawing's connector viewing direction before interpreting pin numbers. Follow the relevant hardware documentation for the master connection and drive IN/OUT port directions.
02A production status and replacement selection
Section 3.2.3 of the 2024 AH Motion hardware manual states that the UC-EMCxxx-02A series was discontinued as of 31 December 2022. The same section lists UC-EMC003-02C as a 0.3-metre option. Preserve the complete identification when assessing installed equipment or older stock, and verify replacement support in the device manual. Do not treat 02A, 02B and 02C suffixes as interchangeable without checking.
Network setup and documentation
A similar RJ45 housing is insufficient. Delta UC-CMC003-01A and Delta CANopen cables serve different signal arrangements. Use Delta industrial network cables and Delta network connectors alongside the technical drawing for the actual port.
The cable has no driver or programming software of its own. For controller projects and network configuration, check Delta ISPSoft support for the CPU through Delta PLC software. Delta AH PLC series and Delta AH Motion backplanes provide supporting information about system layout.
Start document selection at Delta PLC accessories files. Sections 3.3–3.5 of the Delta PLC/HMI Cable Selection Guide, particularly Figure 2 and printed pages 3-10–3-11, describe the connection and series differences. Also read page 3-7 of the AH Motion manual for the discontinuation notice.
Editor's Note
First establish whether 30 centimetres will actually reach. Allow for connector housings, cable turns and maintenance access. Stretching a short cable places strain on the drive port and RJ45 latch.
Inspect both ends of a used cable closely. Look for broken latches, loose metal housings, crushed insulation and sharp damage near the connector. Establish whether the label ends in 02A, 02B or 02C.
An illuminated link LED is insufficient by itself. Compare with a suitable known-good cable and monitor network diagnostic error counters and disconnections. A basic continuity test cannot expose every communication fault occurring during operation.
When interference is suspected, inspect more than the cable. Review routing near motor and braking cables, shield contact and equipment grounding. Follow the manufacturer's arrangement instead of cutting a shield connection experimentally.
Record device order and port directions. Avoid changing several connections simultaneously while isolating a fault. Comparing one connection on a suitable test setup helps distinguish cable damage from project or device settings.
Related topics
Review other connection hardware under Delta PLC accessories and model documentation under Delta PLC and HMI manuals.
External references: Delta PLC/HMI Cable Selection Guide — 2019, English · Delta AH Motion Controller Hardware Manual — 2024, English.