Delta AS16AP11P-A

Delta AS16AP11P-A digital input and PNP output module

The Delta AS16AP11P-A is an AS digital I/O expansion module with 8 digital inputs and 8 PNP transistor outputs. It reads sensors and switches DC loads from a single module in packaging and assembly machines.

24 V DC inputs and S/S common

Inputs IN 0–7 accept 24 V DC signals. Delta’s 2024 module manual lists an input current of 4.2 mA. Wire the S/S input common for the PNP or NPN sensor type. See the AS08AM10N-A and AS16AM10N-A for input-only expansion.

PNP outputs and C0 current limit

Outputs OUT 0–7 switch positive DC voltage to the load. The output supply range is 5–30 V DC. For resistive loads, the limits are 0.5 A per output and 4 A total for the C0 group. Check the load-specific ratings in the manual for coils or lamps. See AS power supplies for supply selection.

For PNP output-only expansion, see the AS08AN01P-A and AS16AN01P-A. The documented maximum switching frequency is 100 Hz for resistive loads. For high-speed pulse positioning, see dedicated modules such as the AS04PU-A.

CPU compatibility and I/O addressing

In an AS200 or AS300 project, add the module in ISPSoft HWCONFIG in its physical position on the right-hand expansion bus. Read the program’s X and Y addresses from the hardware configuration. The 0–7 terminal markings identify the physical channels. See COMMGR and Delta PLC software for PC connection and software.

With the same 8-input and 8-output layout, the AS16AP11T-A has NPN outputs and the AS16AP11R-A has relay outputs. For continuous measurement signals such as 4–20 mA, see the AS04AD-A in the AS analogue measurement modules.

Editor’s Note

On a used module, check the P-A suffix and inspect the removable terminal blocks.
Isolate power and mark the S/S and C0 wires separately before replacement.
On the bench, compare all eight inputs in online monitoring with the module LEDs.
Use a suitable DC test load to check the eight outputs individually.
If an output LED lights but the load stays off, measure the C0 field supply and check the load return.

PDFs and related topics

See our Delta PLC and HMI manuals. In Delta’s module manual, page 2-2 gives the specifications and Section 2.4.11 shows the model-specific wiring diagram.

AS expansion modules · Delta AS PLC series · Delta PLC · Used Delta products

External references · Delta AS module manual (EN) · AS16AP11P-A installation sheet and documents