Delta AHCPU500-RS2
Delta AHCPU500-RS2 PLC CPU with two serial ports
The Delta AHCPU500-RS2 is a basic CPU for the Delta AH500 PLC series. It supports 32K program steps, 128 function blocks and up to 768 local digital I/O points. The system uses one main backplane with up to 12 I/O modules. Its extension-backplane capacity is zero.
Serial communications and CPU features
COM1 and COM2 can each be configured for RS-232, RS-422 or RS-485. The CPU supports Modbus RTU and ASCII over serial. The two ports can serve, for example, an HMI and a drive network independently. See Modbus and RS-485 and Modbus RTU for related information. If the application needs more serial ports, review the AH10SCM-5A module and check for an available slot on the main backplane.
The CPU has 16K D registers and 16K L registers, a Mini USB programming port, and support for standard SD cards up to 2 GB. The AHCPU500-EN offers the same program capacity and local I/O limit with one Ethernet port and one serial port. If the panel uses two serial lines, check how both will connect before selecting the CPU.
ISPSoft and backplane configuration
Program the CPU with Delta ISPSoft. Select the Mini USB connection in COMMGR for initial setup. In HWCONFIG, check the CPU model, module order, I/O start addresses and the mode of each COM port. See Delta PLC programming cables and Delta PLC software for connection resources.
When planning the main backplane, count AH digital modules, AH analog modules and communication modules in the slot layout. For power and mounting components, see AH power supplies and Delta PLC accessories.
Manual and technical PDF
AHCPU500-RS2 specifications (PDF, English) · Section 2.2.1 of the AH500 Hardware and Operation Manual. PDF pages 40–41 cover capacity and serial port specifications. Page 45 shows the front panel and ports.
Editor’s Note
When buying a used CPU, ask for a photo of the full nameplate. Check the 500-RS2 model code and both COM connections.
On the bench, connect to the CPU over Mini USB. If the application uses both serial ports, test COM1 and COM2 separately.
Before moving an existing project, record each port’s protocol, baud rate, parity and station address.
If the main rack is full, check both the extension-backplane requirement and the total I/O count before selecting a CPU.
If the CPU cannot recognise a module, check the power supply, backplane connector and BUS FAULT indicator before replacing the CPU.
Related models and topics
AHCPU501-RS2 48K steps and two serial ports · AHCPU510-RS2 64K steps and one extension backplane · AHCPU520-RS2 128K steps and three extension backplanes.
For a different PLC platform, see Derell B Series PLCs.
Delta AH PLC series · AH expansion modules · Delta PLC · Delta Automation
External reference · Delta AH Series Catalog · CPU model comparison table.