IC697PWR720
Power Supply Adapter Module (IC697PWR720)
This module serves as an interface between an external power supply and the IC697 rack. It provides a convenient way to power an IC697 rack using an external supply.
Features:
Interfaces an external power supply to an IC697 rack.
Single-slot module that plugs into the power supply slot of the rack.
Provides easy connection to the power supply.
Functions:
This Power Supply Adapter Module (PSA) is a single-slot module that plugs into the leftmost power supply slot of an IC697 rack. It must be connected to an external power supply via a cable, which can be an IC697 power supply module or any other compatible external power supply.
The PSA connects the following voltage outputs to the IC697 rack backplane:
+5V
+12V
-12V
The PSA is capable of supplying the following maximum currents to the backplane:
+5V at 18A
+12V at 2A
-12V at 1A
It monitors the +5V output and the TTL-compatible Input Power OK signal from the external power supply. This signal ensures that the external power supply input voltage is sufficient for maintaining hold-up time during an orderly system shutdown.
The PSA generates two critical backplane signals:
ACFAIL*
SYSRESET* (for managing the power-up and power-down sequence).
The external power supply must provide adequate hold-up time (minimum 5.05 milliseconds, per ANSI/IEEE STD 1014-1987) and an Input Power OK signal (TTL) to ensure orderly system shutdown when power is removed.
Operation of the Power Supply Adapter:
The Power Supply Adapter Module operates on +5VDC from the IC697 rack backplane. It is responsible for distributing power from an external power supply to the IC697 backplane.
Dual Rack Operation:
One external power supply can power two racks. In this configuration, the PSA must be installed in the first rack. For details on this configuration, refer to the Programmable Controller Installation Manual.
Mounting:
The Power Supply Adapter is mounted in the leftmost slot of an IC697 rack, connecting to the external power supply through a cable. The cable’s free end must be equipped with spring spade or ring lugs and attached to specific terminals on the PSA’s terminal board, accessed by opening the adapter’s door.
Power Supply Adapter Module Door:
The PSA’s door can be opened easily by pulling gently on the upper left corner with your thumb or fingernail. Be careful not to pull from the bottom to avoid damaging the door or hinge.
Specifications for IC697PWR720:
Power Supply Voltage to Rack Backplane:
+5.02 to +5.12 VDC (5.07V nominal)
+11.58 to +12.42 VDC (+12V nominal)
-11.4 to -12.6 VDC (-12V nominal)
Maximum Power Supply Current to Rack:
+5 VDC at 18A
+12 VDC at 2A
-12 VDC at 1A
Current Drawn from the 5V Bus: 50mA (0.25W)
Ordering Information:
Power Supply Adapter Module: IC697PWR720
Power Supply Extension Cable: IC697CBL700 (includes cable and faceplate for the vacant power supply slot in the second rack)
>> GE Fanuc IC697PWR720 User manual (pdf)
----------
+ Ge-Fanuc Contact (for Automation Mall)