IC697VDQ120
IC697VDQ120 Digital Output, 64-Point, 24VDC Board General Description
The Digital Output Board is capable of delivering 64 channels of high current output. These outputs can be configured as either current sourcing or current sinking. The board is designed with a breakdown voltage of at least 35 V. One of the key features of this board is the Built-in-Test (BIT) logic, which allows the user to verify the operation of each channel under software control.
Key Features of the Digital Output Board
- 64 bits of high current outputs
- Outputs can be current sourcing/High-Z or current sinking
- Outputs are transient protected
- High breakdown voltage (minimum 35 V)
- Tri-state outputs
- Built-in-Test (BIT) logic for fault isolation
- High-reliability DIN-type output connectors
- Supports 8-, 16-, or 32-bit data transfers
- Double Eurocard form factor
- ±3.5 A peak output current (100 ms, 10% duty cycle)
- 500 mA continuous current (fan-cooled)
- Thermal shutdown protection
- Front panel software-controlled Fail LED for Built-in-Test
- Separate user-configurable address jumpers for the Control and Status Register (CSR) and Data Registers allow contiguous data addressing when multiple I/O boards are used in a VMEbus system
Functional Description
The Digital Output Board is designed with common programming features so that subsystems can be configured with contiguous I/O addresses to conserve memory. Each board has two sets of address switches or jumpers, allowing efficient memory mapping for CSR and I/O addresses. The CSR addresses can be configured so that all CSRs from different boards in the system are mapped into contiguous memory locations, separate from the I/O data addresses.
The board features a front panel Fail LED, which illuminates at power-up or after a system reset. This LED can be turned off under program control once board-level diagnostics are successfully completed. Specific hardware on the board supports the Built-in-Test functions, and the board also supports both offline and online fault detection and isolation.
Safety Summary
The following general safety precautions must be observed during all phases of operation, service, and repair of this product. Failure to comply with these precautions or the specific warnings elsewhere in this manual violates safety standards of design, manufacture, and intended use of this product. GE Fanuc assumes no liability for the customer’s failure to comply with these requirements.
- Ground the System: To minimize shock hazard, the chassis and system cabinet must be connected to an electrical ground. A three-conductor AC power cable should be used.
- Do Not Operate in an Explosive Atmosphere: Do not operate the system in the presence of flammable gases or fumes. Operating any electrical system in such an environment constitutes a safety hazard.
- Keep Away from Live Circuits: Operating personnel must not remove product covers. Component replacement and internal adjustments must be performed by qualified maintenance personnel.
- Do Not Service or Adjust Alone: Do not attempt internal service or adjustments unless another person capable of providing first aid and resuscitation is present.
- Do Not Substitute Parts or Modify System: Do not install substitute parts or make unauthorized modifications to the product. Return the product to GE Fanuc for service to ensure that safety features are maintained.
Configuration and Installation
This section provides configuration and installation instructions for the Digital Output Board, and is divided into the following subsections:
- Physical Installation
- Jumper Locations
- Suppressor Diode Connections
- Address Modifiers
- Address Selection Jumpers
- I/O Cable and Front Panel Connector Configuration
- Jumper Functions
Caution: Some components on GE Fanuc products may be sensitive to electrostatic discharge, and damage may occur to boards subjected to high-energy electrostatic fields. Unused boards should be stored in their original protective boxes. When placing the board on a bench for configuration, it is recommended to place a conductive material under the board to provide a conductive shunt.
>> GE Fanuc IC697VDQ120 User manual (pdf)
----------
+ Ge-Fanuc Contact (for Automation Mall)