IC697MDL671
The IC697MDL671 is a 14-Point Interrupt Module designed for use with 24 Volt DC Positive/Negative Logic systems. It provides 16 input points in total, divided into four isolated groups of four points each. Fourteen of these points can be configured as interrupt inputs, while two are reserved for configuration. It is compatible with proximity switches and offers selectable input filtering.
Key Features:
16 input points: Four isolated groups of four points each.
14 interrupt points: Configurable for triggering CPU interrupts.
Positive/Negative logic compatibility: Can sink or source current.
Proximity switch compatibility: Supports both 2-wire and 3-wire sensors.
Selectable input filter: Configurable to 1ms or 10ms.
All 14 interrupts: Can operate at maximum I/O interrupt rate.
Technical Specifications:
Rated Voltage: 24 volts DC.
Inputs per Module: 16 (four groups of four inputs each).
Interrupt Points: 14.
Configuration Points: 2 (D3 and D4).
Input Voltage Range: 20V to 30V DC.
Input Current: 10mA (typical) in the ON state.
Leakage Current: Can accept up to 2mA leakage current in the OFF state.
Filter Delay Time: Configurable to 1ms or 10ms.
Interrupt Frequency: Maximum 500 Hz (depending on CPU model).
Current Required from 5V Bus: 0.53 amps.
Functions:
The interrupt module generates interrupts to the CPU when any of its 14 interrupt inputs meet the configured edge and filter conditions. The first input is always configured as an interrupt. The interrupt word is reported at the module's selected reference address, which the CPU reads and acknowledges. The module is then ready to handle the next interrupt.
The module includes LED indicators to show the ON-OFF status of each point, providing visual feedback for troubleshooting and monitoring. Configuration is done using MS-DOS or Windows-based programming software, which can be connected via Ethernet TCP/IP or SNP port.
Input Characteristics:
This module is designed to work with a variety of input devices, including:
Pushbuttons, limit switches, and selector switches;
Electronic proximity switches, both 2-wire and 3-wire.
The input circuitry ensures reliable operation by sourcing or sinking current, with an input current of 10mA in the ON state. The module is compatible with many 2-wire proximity switches, but each type must be evaluated for compatibility with both ON and OFF states.
Interrupt Configuration:
D3 and D4 configuration inputs: These inputs determine the trigger edge and filter delay at power-up. If D3 is activated, the module will detect falling edges. If D4 is activated, it sets a 10ms filter delay.
Interrupt Handling: The interrupts are edge-triggered and can be set to respond to either rising or falling edges. The module can handle multiple interrupts at once and reports them as one word to the CPU.
Mechanical Keying:
The module includes a mechanical key to prevent incorrect installation. Once inserted, the key latches onto the backplane rail, ensuring that only the correct type of module can be used in that slot.
Removal Instructions:
Grasp the module firmly at the top and bottom.
Squeeze the rack clips to release the module from the rail.
Slide the module along the guide and remove it from the backplane connector.
>> GE Fanuc IC697MDL671 User manual (pdf)
----------
+ Ge-Fanuc Contact (for Automation Mall)