IC697MDL241

The IC697MDL241 is a 240 Volt AC input module with 16 isolated input points. This module allows each point to be connected to a different phase of the AC power supply and is designed to meet IEC standards. It is compatible with proximity switches and is widely used in industrial automation systems.

Key Features:

    16 individually isolated input points: Each input point is independently isolated from the others.

    20 ms input filter: Ensures stable and accurate signal processing.

    Proximity switch compatibility: Works with both 2-wire and 3-wire proximity switches.

    LED indicators: LED lights at the top of the module show the ON-OFF status of each input point.

    Mechanical keying: Prevents incorrect module placement, ensuring the correct type of module is used.

Technical Specifications:

    Rated Voltage: 240 VAC, 60 Hz sinusoidal.

    Input Isolation: 1500 volts RMS isolation from any input to the backplane, and 500 volts RMS between input groups.

    Input Current: Typically draws 20mA at rated voltage, with ON-state current between 10mA and 15mA, and OFF-state current up to 5mA.

    Input Characteristics:

        ON-state voltage: 160 to 264 volts AC.

        OFF-state voltage: 0 to 40 volts AC.

        OFF-state current: Can handle up to 5mA of leakage current.

    Filter Delay: A typical delay of 20ms for input signal filtering.

    Power Consumption: Draws 0.25 amps from the 5V backplane bus.

    VME Compatibility: Supports the VME standard for broader system compatibility.

Installation and Field Wiring:

    Field Wiring: The terminal board accepts wire sizes from #22 AWG to #14 AWG, and allows two wires of the same size to be terminated on a single terminal. Each input is isolated, so each input requires a separate power source connection.

    Cable Management: The wire bundle can be neatly secured to the terminal board using cable ties, ensuring organized and secure connections.

Mechanical Keying:

The module features a mechanical key that ensures it is placed in the correct slot. When first installed, the key latches onto the backplane rail, configuring the slot to accept only identical module types. If needed, the key can be removed and reinserted into a different slot.

Removal Instructions:

    Firmly grasp the top and bottom of the module cover.

    Squeeze the rack clips on the back to disengage them from the rack rail.

    Slide the module out of the card guide and carefully remove it from the backplane connector.

Practical Tips:

When using this module, keep in mind that each input is isolated and requires its own power source. In environments with electrical noise, make use of the 20ms input filter feature to ensure accurate signal processing. Additionally, be sure to select the appropriate wire size for connections to maintain system reliability and longevity.