IC697ACC903

RS-485 Port Isolator (IC697ACC903)

The IC697ACC903 RS-485 Port Isolator replaces the older IC655CMM590 Isolated Repeater/Converter and provides electrical isolation for RS-485 communications in IC693, IC697, and IC200 PLC product lines. It offers enhanced electromagnetic compatibility and supports both single- and multi-drop operations.

Key Features:

    500 volts isolation for signal channels
    RS-485 compatibility supporting both single- and multi-drop configurations
    Hot insertion support, allowing the device to be inserted or removed without powering down the system
    Opto-isolated channels: SD, RD, RTS, and CTS
    A DC/DC converter for power isolation
    Termination resistor for multi-drop configurations

Physical Dimensions:

    Front view: 1.7 in (height), 0.7 in (width)
    Top view: 2.6 in (length)

Connectors:

The port isolator has two connectors:

    PL1 (15-pin male D-type)
    PL2 (15-pin female D-type)

Connector Pin Assignments:
PL1 Pin    Pin Name    Description
1    SHLD    Chassis Ground
5    5V    +5V power
6    CTS (A’)    Clear to Send (in)
7    0V    Signal Ground
8    RTS (B)    Request to Send (out)
10    SD (A)    Send Data (out)
11    SD (B)    Send Data (out)
12    RD (A’)    Receive Data (in)
13    RD (B’)    Receive Data (in)
14    CTS (B’)    Clear to Send (in)
15    RTS (A)    Request to Send (out)


Block Diagram:

The isolator uses opto-isolators for signal channels and a DC/DC converter for power isolation. It supports both single-port and multi-drop configurations, with a switch to toggle between the two modes.
Installation:

The isolator can be mounted directly to a serial port or attached using the provided 12-inch extender cable for panel-mounted applications. The device is secured using M3 thumbscrews. For panel mounting, two #6–32 screws are required.


Torque Specifications:

    Connector Thumbscrews: M3, 8 in/lbs (0.9 Nm)
    Panel Mounting Screws: #6–32 (4 mm), 12 in/lbs (1.4 Nm)

Multi-Drop Configuration:

The RS-485 Port Isolator can be used in multi-drop configurations, with up to 8 devices on the same network. The first and last devices in the chain should have the terminating resistor installed.

For detailed wiring instructions, consult the Serial Communications User’s Manual (GFK-0582).

This isolator is an ideal solution for providing robust and reliable RS-485 communication in industrial environments, especially when high electromagnetic compatibility is required.